hsdl3602 Avago Technologies, hsdl3602 Datasheet - Page 19

• Manufacturer Part Number: hsdl3602
• Description: Agilent Hsdl-3602 Irda Data 1.4 Compliant 4 Mb/s 3v Infrared Transceiver
• Manufacturer: Avago Technologies

(B) HSDL-3602 Interoperability with
National Semiconductor
PC97338VJG SIO Evaluation Report
Introduction
The objective of this report is to
demonstrate the interoperability
of the HSDL-3602 IR transceiver
IR module as wireless communi-
cation ports at the speed of 2.4
kb/s - 4 Mb/s with NS’s
PC97338VJG Super I/O under
typical operating conditions.
Test Procedures
(1) Two PC97338VJG evalua-
HSDL-3602 Interoperability with NS
PC97338 Report
(i) Test Conditions
V
RLED = 2.7
Optical transmitter pulse
Mode set to full power
19
width = 125 ns
CC
= 3.0 – 3.6 V
tion boards were connected
to the ISA Bus of two PCs
(Pentium 200 MHz) running
RD, WR, CS
DACK, TC
A0 - A3
D0 - D7
DRQ
IRQ
14.314 MHz
SEMICONDUCTOR
CLOCK
PC97338VJG
NATIONAL
SUPER I/O
(2) The test software used in
(ii) Test Result
The interoperability test results
show that HSDL-3602 IR trans-
ceiver can operate
link distance from 3 V to 3.6 V
with NS’s PC97338 at any IrDA
1.1 data rate without error.
IRTX (63)
IRRX1 (65)
IRSL0 (66)
Microsoft’s DOS operating
system. One system with an
HSDL-3602 IR transceiver
connected to the
PC97338VJG evaluation
board will act as the master
device. Another system with
an HSDL-3602 IR trans-
ceiver connected to the
PC97338VJG will act as the
slave device (i.e. Device
Under Test).
this interoperability test is
provided by National Semi-
conductor. A file size of
* MODE GROUND FOR
FULL POWER OPERATION
*
FIR_SEL (3)
MD0 (4)
MD1 (5)
RXD (8)
TXD (9)
*
1.5 meter
GND (7)
HSDL 3602
HSDL-3602
(3) The link distance is mea-
V
AGND (2)
CC
SP
LEDA (10)
R1
1.7M byte from the master
device, with the
PC97338VJG performing
the framing, encoding is
transmitted to the slave
device. The slave device,
with the PC97338VJG per-
forming the decoding, and
CRC checksum, will receive
the file. The file is then
checked for error by com-
paring the received file with
the original file using the
DOS “fc” command.
sured by adjusting the dis-
tance between the master
and slave for errorless data
communications.
CX1
CX2
V
CC
(1)