at89c51cc03c-slsim ATMEL Corporation, at89c51cc03c-slsim Datasheet - Page 49

• Manufacturer Part Number: at89c51cc03c-slsim
• Description: At89c51cc03 Enhanced 8-bit Mcu With Can Controller And Flash Memory
• Manufacturer: ATMEL Corporation

4182N–CAN–03/08
order. The page address of the last address loaded in the column latches will be used
for the whole page.
When programming is launched, an automatic erase of the locations loaded in the col-
umn latches is first performed, then programming is effectively done. Thus no page or
block erase is needed and only the loaded data are programmed in the corresponding
page
Notes:
The following procedure is used to load the column latches and is summarized in
Figure 25:
•
•
•
•
•
•
•
Save and Disable interrupt and map the column latch space by setting FPS bit.
Load the DPTR with the address to load.
Load Accumulator register with the data to load.
Execute the MOVX @DPTR, A instruction.
If needed loop the three last instructions until the page is completely loaded.
unmap the column latch.
Restore Interrupt
1. : If no bytes are written in the column latches the SEQERR bit in the FSTA register
2. When a flash write sequence is in progress (FBUSY is set) a write sequence to the
3. MOVX @DPTR, A instruction must be used to load the column latches. Never use
4. When a programming sequence is launched, Flash bytes corresponding to activated
will be set.
column latches will be ignored and the content of the column latches at the time of
the launch write sequence will be preserved.
MOVX @Ri, A instructions.
bytes in the column latches are first erased then the bytes in the column latches are
copied into the Flash bytes. Flash bytes corresponding to bytes in the column latches
not activated (not loaded during the load column latches sequence) will not be erased
and written.
49