dsp56004 Freescale Semiconductor, Inc, dsp56004 Datasheet - Page 24

• Manufacturer Part Number: dsp56004
• Description: Symphonytm Audio Dsp Family 24-bit Digital Signal Processors
• Manufacturer: Freescale Semiconductor, Inc

Signal/Connection Descriptions
On-Chip Emulation (OnCE
1-18
DR
Signal
Name
Signal
Input
Type
Table 1-12 On-Chip Emulation Port Signals (Continued)
TM
State during
) Port
Freescale Semiconductor, Inc.
Reset
Input
For More Information On This Product,
DSP56004/D, Rev. 3
Go to: www.freescale.com
Debug Request (DR)—The debug request input provides a
means of entering the Debug mode of operation. This signal,
when asserted (pulled low), will cause the DSP to finish the
current instruction being executed, to save the instruction
pipeline information, to enter the Debug mode, and to wait
for commands to be entered from the debug serial input line.
While the DSP is in the Debug mode, the user can reset the
OnCE port controller by asserting DR, waiting for an
acknowledge pulse on DSO, and then deasserting DR. It
may be necessary to reset the OnCE port controller in cases
where synchronization between the OnCE port controller
and external circuitry is lost. Asserting DR when the DSP is
in the Wait or the Stop mode, and keeping it asserted until
an acknowledge pulse in the DSP is produced, puts the DSP
into the Debug mode. After receiving the acknowledge
pulse, DR must be deasserted before sending the first OnCE
port command. For more information, see Methods Of
Entering The Debug Mode in the
Manual
Note:
If the OnCE port is not in use, an external pull-up resistor
should be attached to the DR line.
.
Signal Description
DSP56000 Family
MOTOROLA