sam4s8c ATMEL Corporation, sam4s8c Datasheet - Page 17

• Manufacturer Part Number: sam4s8c
• Description: At91sam Arm-based Flash Mcu
• Manufacturer: ATMEL Corporation

5. Power Considerations
5.1
5.2
5.3
11100AS–ATARM–27-Oct-11
Power Supplies
Voltage Regulator
Typical Powering Schematics
The SAM4S has several types of power supply pins:
The SAM4S embeds a voltage regulator that is managed by the Supply Controller.
This internal regulator is designed to supply the internal core of SAM4S It features two operating
modes:
For adequate input and output power supply decoupling/bypassing, refer to the “Voltage Regula-
tor” section in the “Electrical Characteristics” section of the datasheet.
The SAM4S supports a 1.62V-3.6V single supply mode. The internal regulator input is con-
nected to the source and its output feeds VDDCORE.
schematics.
As VDDIN powers the voltage regulator, the ADC, DAC and the analog comparator, when the
user does not want to use the embedded voltage regulator, it can be disabled by software via
the SUPC (note that this is different from Backup mode).
• VDDCORE pins: Power the core, the embedded memories and the peripherals. Voltage
• VDDIO pins: Power the Peripherals I/O lines (Input/Output Buffers), USB transceiver, Backup
• VDDIN pin: Voltage Regulator Input, ADC, DAC and Analog Comparator Power Supply.
• VDDPLL pin: Powers the PLLA, PLLB, the Fast RC and the 3 to 20 MHz oscillator. Voltage
• In Normal mode, the voltage regulator consumes less than 500 µA static current and draws
• In Backup mode, the voltage regulator consumes less than 3 µA while its output (VDDOUT)
ranges from 1.08V to 1.32V.
part, 32 kHz crystal oscillator and oscillator pads. Voltage ranges from 1.62V to 3.6V.
Voltage ranges from 1.62V to 3.6V.
ranges from 1.08V to 1.32V.
80 mA of output current. Internal adaptive biasing adjusts the regulator quiescent current
depending on the required load current. In Wait Mode quiescent current is only 5 µA.
is driven internally to GND. The default output voltage is 1.20V and the start-up time to reach
Normal mode is less than 300 µs.
Figure 5-1
below shows the power
17