ds26503 Maxim Integrated Products, Inc., ds26503 Datasheet - Page 20

• Manufacturer Part Number: ds26503
• Description: T1/e1/j1 Bits Element
• Manufacturer: Maxim Integrated Products, Inc.

WR (R/W)/
ALE (AS)/
BTS/HBE
RMODE2
TMODE3
A7/MPS1
RD(DS)/
CS/RLB
NAME
TYPE
I
I
I
I
I
Bus Type Select/Transmit and Receive B8ZS/HDB3 Enable
BTS: Strap high to select Motorola bus timing; strap low to select Intel bus
timing. This pin controls the function of the RD (DS), ALE (AS), and WR
(R/W) pins. If BTS = 1, then these pins assume the function listed in
parentheses ().
HBE: In Hardware Mode (BIS[1:0] = 11), this pin enables transmit and receive
B8ZS/HDB3 when in T1/E1 operating modes.
Read Input-Data Strobe/Receive Mode Select Bit 2
RD
= 01. See the bus timing diagrams.
RMODE2: In Hardware Mode (BIS[1:0] = 11), this pin selects the receive side
operating mode.
Chip Select/Remote Loopback Enable
CS
signal is used for both the parallel port and the serial port modes.
RLB: In Hardware Mode (BIS[1:0] = 11), when high, remote loopback is
enabled. This function is only valid when the transmit side and receive side are
in the same operating mode.
Address Latch Enable (Address Strobe)/Address Bus Bit 7/MCLK
Prescale Select 1
ALE (AS): In multiplexed bus operation (BIS[1:0] = 00), it serves to
demultiplex the bus on a positive-going edge.
A7: In nonmultiplexed bus operation (BIS[1:0] = 01), this pin serves as A[7].
MPS1: In Hardware Mode (BIS[1:0] = 11), MCLK prescale select, used to set
the prescale value for the PLL.
Write Input (Read/Write)/Transmit Mode Select 3
WR
TMODE3: In Hardware Mode, this pin selects the transmit-side operating
mode.
: This active-low signal must be low to read or write to the device. This
: In Processor Mode, this pin is the active-low write signal.
(
DS
): These pins are active-low signals. DS is active high when BIS[1:0]
20 of 122
FUNCTION