AN1154 STMicroelectronics, AN1154 Datasheet - Page 41

• Manufacturer Part Number: AN1154
• Description: 8031-PSD DESIGN TUTORIAL
• Manufacturer: STMicroelectronics

Figure 41. PSD Pro
Next, you will see that the Auto Select option becomes active. This means that PSDsoft will automatically
detect to which PC parallel port your PSDpro is connected. Just click OK, and the PSDpro will be detected
and configured if the connections are good.
The same menu options and capabilities that apply to the MagicProIII in the section above also apply to
the PSDpro.
JTAG: FlashLink
If you have a FlashLink cable installed on one of your PC’s parallel ports, you can select and configure it
as follows:
1. Go to the Options menu in the PSD Programmer environment, and select Hardware Setup. Once the
Figure 42. FlashLink
2. Next, you will see that the Auto Select option becomes active, as well as Loop Test, as shown in
“PSD Programmer – Hardware Setup” dialog box appears, select FlashLink, in the “Hardware Section”,
as shown in Figure 42.
Figure 43.
AN1154 - APPLICATION NOTE
AI03178
AI03179
41/83