AN1154 STMicroelectronics, AN1154 Datasheet - Page 40

• Manufacturer Part Number: AN1154
• Description: 8031-PSD DESIGN TUTORIAL
• Manufacturer: STMicroelectronics

AN1154 - APPLICATION NOTE
Figure 39. PSD Programmer – Program Confirmation
2. Select “All”, as shown in Figure 39.
3. Place the PSD device into the programmer, checking that it is correctly orientated, and snap the lid
PSDpro
If you have a PSDpro connected to one of your PC’s parallel ports, you can select and configure it by going
to the Options menu in the PSD Programmer environment and selecting Hardware Setup, as shown in
Figure 40.
Figure 40. PSD Programmer – Hardware Setup
Once the “PSD Programmer – Hardware Setup” dialog box appears, select PSDpro, in the “Hardware
Section”, as shown in Figure 41.
40/83
down on the device carrier. Then, click on the OK button. As programming takes place, the MagicProIII
programmer checks each location, after it is programmed, to make sure it matches the contents in the
.obj file. If a particular location cannot be programmed properly, an error message is shown. If this
occurs, you must restart from the beginning, and program a fully erased and functional part.
AI03176
AI03177