B121EW04-V1 AUO, B121EW04-V1 Datasheet - Page 4

• Manufacturer Part Number: B121EW04-V1
• Description: WXGA Color TFT-LCD
• Manufacturer: AUO

PDF created with pdfFactory Pro trial version
1) Since front polarizer is easily damaged, pay attention not to scratch it.
2) Be sure to turn off power supply when inserting or disconnecting from input connector.
3) Wipe off water drop immediately. Long contact with water may cause discoloration or spots.
4) When the panel surface is soiled, wipe it with absorbent cotton or other soft cloth.
5) Since the panel is made of glass, it may break or crack if dropped or bumped on hard surface.
6) Since CMOS LSI is used in this module, take care of static electricity and insure human earth when
7) Do not open nor modify the Module Assembly.
8) Do not press the reflector sheet at the back of the module to any directions.
9) In case if a Module has to be put back into the packing container slot after once it was taken out
10) At the insertion or removal of the Signal Interface Connector, be sure not to rotate nor tilt the
11) After installation of the TFT Module into an enclosure (Notebook PC Bezel, for example), do not
12) Cold cathode fluorescent lamp in LCD contains a small amount of mercury. Please follow local ordinances
13) Small amount of materials having no flammability grade is used in the LCD module. The LCD module
14) The LCD module is designed so that the LED in it is supplied by Limited Current Circuit (IEC60950 or
1. Handling Precautions
document version 0.1
handling.
from the container, do not press the center of the LED Reflector edge. Instead, press at the far ends
of the CFL Reflector edge softly. Otherwise the TFT Module may be damaged.
Interface Connector of the TFT Module.
twist nor bend the TFT Module even momentary. At designing the enclosure, it should be taken into
consideration that no bending/twisting forces are applied to the TFT Module from outside.
Otherwise the TFT Module may be damaged.
or regulations for disposal.
should be supplied by power complied with requirements of Limited Power Source (IEC60950 or UL1950),
or be applied exemption.
UL1950). Do not connect the LED in Hazardous Voltage Circuit.
Product Specification
B121EW04 V1
www.pdffactory.com
www.DataSheet.co.kr
4
Datasheet pdf - http://www.DataSheet4U.net/