T315XW02-VT AUO, T315XW02-VT Datasheet - Page 29

• Manufacturer Part Number: T315XW02-VT
• Description: LCD Module
• Manufacturer: AUO

©Copyright AU Optronics, Inc.
January, 2003 All Rights Reserved.
No Reproduction and Redistribution Allowed
www.DataSheet4U.net
9. PRECAUTIONS
9-1 MOUNTING PRECAUTIONS
9-2 OPERATING PRECAUTIONS
Please pay attention to the followings when you use this TFT LCD module.
(1) You must mount a module using holes arranged in four corners or four sides.
(2) You should consider the mounting structure so that uneven force (ex. Twisted stress) is not
applied to module. And the case on which a module is mounted should have sufficient strength so
that external force is not transmitted directly to the module.
(3) Please attach the surface transparent protective plate to the surface in order to protect the
polarizer. Transparent protective plate should have sufficient strength in order to the resist external
force.
(4) You should adopt radiation structure to satisfy the temperature specification.
(5) Acetic acid type and chlorine type materials for the cover case are not desirable because the
(6) Do not touch, push or rub the exposed polarizer with glass, tweezers or anything harder than
(7) When the surface becomes dusty, please wipe gently with absorbent cotton or other soft
(8) Wipe off saliva or water drops as soon as possible. Their long time contact with polarizer
(9) Do not open the case because inside circuits do not have sufficient strength.
(1) The device listed in the product specification sheets was designed and manufactured for TV
(2) The spike noise causes the mis-operation of circuits. It should be lower than following voltage:
(3) Response time depends on the temperature. (In lower temperature, it becomes longer..)
(4) Brightness depends on the temperature. (In lower temperature, it becomes lower.) And in
(5) Be careful for condensation at sudden temperature change. Condensation makes damage to
(6) When fixed patterns are displayed for a long time, remnant image is likely to occur.
(7) Module has high frequency circuits. Sufficient suppression to the electromagnetic interference
HB pencil lead. And please do not rub with dust clothes with chemical treatment. Do not
touch the surface of polarizer for bare hand or greasy cloth. (Some cosmetics are detrimental
to the polarizer.)
materials like chamois soaks with petroleum benzene. Normal-hexane is recommended for
cleaning the adhesives used to attach front/ rear polarizer. Do not use acetone, toluene and
alcohol because they cause chemical damage to the polarizer.
causes deformations and color fading.
former generates corrosive gas of attacking the polarizer at high temperature and the latter
causes circuit break by electro-chemical reaction.
application
V=±200mV(Over and under shoot voltage)
lower temperature, response time (required time that brightness is stable after turned on)
becomes longer.
polarizer or electrical contacted parts. And after fading condensation, smear or spot will occur.
shall be done by system manufacturers. Grounding and shielding methods may be important
to minimize the interface.
T315XW02 VT - Specs. ver 0.1
29/31