T210A103J075PS Kemet Corp., T210A103J075PS Datasheet - Page 21

• Manufacturer Part Number: T210A103J075PS
• Description: GR500 High Reliability Solid Tantalum Capacitors; Capacitance: 0.01uF; Voltage: 75V; Tolerance: ±5%; Body Size: 0.250" x 0.125" Lead Style: Axial; Body Style: Hermetically-Sealed; Features: P Failure Rate
• Manufacturer: Kemet Corp.

tors shall then be discharged for 4 ± 1 seconds to a voltage
which is less than 1% of rated voltage. Total resistance of the
wiring, fixturing and power supply output, but exclusive of
the capacitor under test, shall be 1.0 ohms max. After test,
the capacitors shall meet the following requirements:
Note: Rated Voltages ≥75V shall be tested at max 70V.
4.5.18 Life (see 3.5.19)
4.5.18.1 Life—Acceptance Inspection (see Table 3)—
Capacitors shall be tested as specified in 4.6.19.1. The fol-
lowing exceptions apply:
4.5.19 Resistance to solvents (see 3.5.20)—Capacitors
shall be tested in accordance with MIL-STD-202. Method
215. The following details apply:
4.5.20 Resistance to soldering heat (see 3.5.21)—
Capacitors shall be tested in accordance with MIL-STD-
202, Method 210. The following details apply:
a) Sample size shall be in accordance with Table 2 or 4 as
b) The marked portion of the capacitor body shall be
c) After test, capacitors shall be examined for physical or
a) Test condition letter—B
b) Depth of lead immersion in molten solder shall be
c) Cooling time prior to measurements after test shall be
DCL — Per applicable detail specification.
Cap — Within ± 2% of initial measured value.
D.F. — Per applicable detail specification.
a) Test condition letter-F (2,000 hours)
b) The test temperature shall be
c) DC leakage
d) Measurements after test—Per 4.5.19.l(g)
applicable.
brushed.
mechanical damage and deterioration or obliteration of
marking.
1,000
2,000
within 0.250 inches of the case, tubulation, or seal.
30 minutes minimum.
125°
(at the applicable high test temperature)
shall be measured at 0;
250
© KEMET Electronics Corporation • P.O. Box 5928 • Greenville, SC 29606 [phone] • www.kemet.com
+4°/-0°
GR500 GRADED RELIABILITY SPECIFICATION (Continued)
+48/-0
+72/-0 hours
+48/-0
GR500 GRADED RELIABILITY SPECIFICATIONS
5. PREPARATION FOR DELIVERY
5.1 Leads—Capacitor leads shall be straightened prior to
packaging.
5.2 Packaging methods—Capacitors shall be packaged in
individual container compartments. Packaging methods and
materials used shall prevent degradation of capacitor char-
acteristics as determined by this specification.
d) After test, DC leakage. capacitance. and dissipation
e) Capacitors shall be examined for external physical or
factor measurements shall be made in accordance with
4.5.4, 4.5.5, and 4.5.6.
mechanical damage.
19