STGIPN3H60 STMicroelectronics, STGIPN3H60 Datasheet - Page 16

• Manufacturer Part Number: STGIPN3H60
• Manufacturer: STMicroelectronics

Application information
5.1
16/20
Recommendations
●
●
●
●
●
●
●
●
Input signal HIN is active high logic. An 85 kΩ (typ.) pull-down resistor is built-in for
each high side input. If an external RC filter is used for noise immunity, attention should
be given to the variation of the input signal level.
Input signal LIN is active low logic. A 720 kΩ (typ.) pull-up resistor, connected to an
internal 5 V regulator through a diode, is built-in for each low side input.
To prevent input signal oscillation, the wiring of each input should be as short as
possible.
By integrating an application-specific type HVIC inside the module, direct coupling to
the MCU terminals without an opto-coupler is possible.
Each capacitor should be located as close as possible to the pins of the IPM.
Low inductance shunt resistors should be used for phase leg current sensing.
Electrolytic bus capacitors should be mounted as close to the module bus terminals as
possible. Additional high frequency ceramic capacitors mounted close to the module
pins will further improve performance.
The SD/OD signal should be pulled up to 5 V / 3.3 V with an external resistor (see
Section 4: Smart shutdown function
Doc ID 018957 Rev 1
for detailed info).
STGIPN3H60