TSS463-AA ATMEL Corporation, TSS463-AA Datasheet - Page 52
TSS463-AA
Manufacturer Part Number
TSS463-AA
Description
Van (ISO Standard 11519-3) Datalink Controller With Serial Interface.
Manufacturer
ATMEL Corporation
Datasheet
1.TSS463-AA.pdf
(60 pages)
- Current page: 52 of 60
- Download datasheet (2Mb)
Activate, Idle and
Sleep Modes
Idle and Activate
Commands
Figure 35. Idle and Activate Timings
Sleep Command
52
TSS463-AA
After Reset
INT
RxD
TxD
RxD
Idle Mode
FCS
Sleep, idle and activate commands are located in the Command Register (0x03). These
three commands are general commands for the TSS463AA.
After reset, the TSS463AA starts in idle mode. In this mode, the oscillator operates
(CKOUT pin active) but the circuit cannot transmit or receive anything on the VAN bus.
The TxD output (pin 12) is in tri-state mode, a pull-up resistor must be provided exter-
nally or by the line driver to avoid floating state on the VAN bus. To activate the
TSS463AA, the user must set the activate bit (ACTI) and reset the idle bit (IDLE).
In both cases, the idle state can be verified reading the Line Status register (0x04).
If the user sets the sleep bit (SLEEP), the TSS463AA enters in sleep mode, regardless
of the values of activate and idle bits. It means that, all non-user registers are set-up to
reduce the power consumption and the internal oscillator is immediately stopped. Then,
accesses to all registers (and to the messages) via the SPI/SCI interface are impossible
and CKOUT is not provided.
To exit from this mode the user must apply either an hardware reset (external reset pin)
either an asynchronous software reset (via the SPI/SCI interface).
In a typical application (see Figure 5), using the CKOUT feature (pin 8), if the
TSS463AA is put in sleep mode, the clock provided to the microcontroller is stopped.
So, the system does not run and the only way to awake this application is an external
reset.
Idle Command
(max)
3 TS
Activate Mode
Activate command
8 TS
12 TS
4 TS
5 TS
Activate Mode
SOF
SOF
TS: Timeslot Period
Idle Mode
4205A–AUTO–03/03
Related parts for TSS463-AA
Image
Part Number
Description
Manufacturer
Datasheet
Request
R
Part Number:
Description:
VAN Data Link Controller with Serial Interface
Manufacturer:
ATMEL Corporation
Datasheet:
Part Number:
Description:
VAN Data Link Controller with Serial Interface
Manufacturer:
ATMEL [ATMEL Corporation]
Datasheet:
Part Number:
Description:
Tact Switch
Manufacturer:
ETC-unknow
Datasheet:
Part Number:
Description:
Smd Type Crystal Units For Automobile Application
Manufacturer:
TOKYO DENPA CO.,LTD
Datasheet:
Part Number:
Description:
Smd Type Crystal Units For Automobile Application
Manufacturer:
TOKYO DENPA CO.,LTD
Datasheet:
Part Number:
Description:
Surface Mount Type Crystal Units
Manufacturer:
TOKYO DENPA CO.,LTD
Datasheet:
Part Number:
Description:
Surface Mount Type Crystal Units
Manufacturer:
TOKYO DENPA CO.,LTD
Datasheet:
Part Number:
Description:
Surface Mount Type Crystal Units
Manufacturer:
TOKYO DENPA CO.,LTD
Datasheet:
Part Number:
Description:
Miniature Surface Mount Type Crystal Units
Manufacturer:
TOKYO DENPA CO.,LTD
Datasheet:
Part Number:
Description:
TANTALUM CHIP TANGOLDTM CAPACITORS
Manufacturer:
RCD [RCD COMPONENTS INC.]
Datasheet:
Part Number:
Description:
TACT SWITCH
Manufacturer:
ETC1 [List of Unclassifed Manufacturers]
Datasheet:
Part Number:
Description:
INTERVAL AND WIPE/WASH WIPER CONTROL IC WITH DELAY
Manufacturer:
ATMEL Corporation
Datasheet:
Part Number:
Description:
Low-Voltage Voice-Switched IC for Hands-Free Operation
Manufacturer:
ATMEL Corporation
Datasheet:
Part Number:
Description:
MONOLITHIC INTEGRATED FEATUREPHONE CIRCUIT
Manufacturer:
ATMEL Corporation
Datasheet: