STK672-432A-E Sanyo Semicon Device, STK672-432A-E Datasheet - Page 10

• Manufacturer Part Number: STK672-432A-E
• Description: 2-phase Stepping Motor Driver
• Manufacturer: Sanyo Semicon Device

www.DataSheet.co.kr
Usage Notes
1. I/O Pins and Functions of the Control Block
[Pin description]
Description of each pin
[CLOCK (Phase switching clock)]
[CWB (Motor direction setting)]
[ENABLE (Forcible OFF control of excitation drive output A, AB, B, and BB, and selecting operation/hold status
inside the HIC)]
[MODE1, MODE2, and MODE3 (Selecting the excitation mode, and selecting one edge or both edges of the CLOCK)]
[RESETB (System-wide reset)]
The reset signal is formed by the power-on reset function built into the HIC and the RESETB terminal.
When activating the internal circuits of the HIC using the power-on reset signal within the HIC, be sure to connect Pin
14 of the HIC to V DD .
When CWB=0: The motor rotates in the clockwise direction.
When CWB=1: The motor rotates in the counterclockwise direction.
Do not allow CWB input to vary during the 7μs interval before and after the rising and falling edges of CLOCK input.
Input frequency: DC-20kHz (when using both edges) or DC-50kHz (when using one edge)
Minimum pulse width: 20μs (when using both edges) or 10μs (when using one edge)
Pulse width duty: 40% to 50%
Both edge, single edge operation
ENABLE=1: Normal operation
When ENABLE=0: Motor current goes OFF, and excitation drive output is forcibly turned OFF.
The system clock inside the HIC stops at this time, with no effect on the HIC even if input pins other than RESET
input vary. In addition, since current does not flow to the motor, the motor shaft becomes free.
If the CLOCK signal used for motor rotation suddenly stops, the motor shaft may advance beyond the control position
due to inertia. A SLOW DOWN setting where the CLOCK cycle gradually decreases is required in order to stop at the
control position.
Excitation select mode terminal (See the sample application circuit for excitation mode selection), selecting the
CLOCK input edge(s).
Mode setting active timing
Do not change the mode within 7μs of the input rising or falling edge of the CLOCK signal.
M3:1 The excitation phase moves one step at a time at the rising edge of the CLOCK pulse.
M3:0 The excitation phase moves alternately one step at a time at the rising and falling edges of the CLOCK pulse.
HIC pin
19
10
11
17
12
13
14
15
16
7
8
Pin Name
RESETB
ENABLE
FAULT1
FAULT2
MODE1
MODE2
MODE3
CLOCK
CWB
MOI
Vref
STK672-432A-E
Output pin for the excitation monitor
Current value setting
Excitation mode selection
External CLOCK (motor rotation instruction)
Sets the direction of rotation of the motor axis
System reset
Motor current OFF
Overcurrent/over-heat detection output
Function
No.A1586-10/21
Datasheet pdf - http://www.DataSheet4U.net/