TLE 7810G Infineon Technologies, TLE 7810G Datasheet - Page 13

• Manufacturer Part Number: TLE 7810G
• Manufacturer: Infineon Technologies

Specifications of TLE 7810G

• Packages: PG-DSO-28
• Flash: 16.0 kByte
• Frequency (f): 24.0 MHz
• High Side Switch: 1
• High Voltage Monitor Input: 5
• Gpio: 8

4.5
4.5.1
During SBC Sleep Mode (see
regulator switched-off. As the microcontroller cannot be supplied, the integrated window watchdog can be disabled
in Sleep Mode via a dedicated SPI control bit. However, it can be turned-on for periodically waking-up the system,
e.g. ECU, by generating a reset and automatically switching to SBC Standby Mode.
This mode is entered via SPI command, and turns-off the integrated LIN bus transceiver, main voltage regulator
as well as all switches. Upon a voltage level change at the monitoring / wake-up pins or by LIN message the SBC
Sleep Mode will be terminated and the SBC Standby Mode will automatically be entered (turning-on the LDO).
Note: Upon a wake-up via LIN message the (internal) RxD signal stays “low” until mode switch.
Note: If the Window Watchdog was not enabled in Sleep Mode the Window Watchdog starts after wake-up with a
Note: In Sleep Mode with activated watchdog (see
Figure 6
Data Sheet
MS2
“long open window” in SBC Standby Mode.
remains turned on.
0
SBC Active Mode
MS1
Power Saving Modes
SBC Sleep Mode
State Diagram “SBC Sleep Mode”
1
MS0
0 / 1
„single“ µController SPI -Command:
- select SBC Sleep Mode via SPI Mode Bits
- window watchdog activation / deactivation via SPI
[can remain active as periodic reset timer ]
Vcc
ON
MS2
Figure
1
SBC Sleep Mode
MS1
6), the lowest power consumption is achieved, by having its main voltage
0
MS0
0
Table 2 “SPI Input Data Bits” on Page
OFF
Vcc
13
SBC Standby Mode
Vcc
ON
transition caused by :
- event at MONx inputs
- LIN message
[SPI indicates source]
Rev. 3.01, 2008-04-15
21) the oscillator
Operating Modes
Power Up
Start Up
TLE7810G