LPC1114FHN33 NXP Semiconductors, LPC1114FHN33 Datasheet - Page 66

• Manufacturer Part Number: LPC1114FHN33
• Description: The LPC1114FHN33 is an ARM Cortex-M0 microcontroller and it can operate up to 50 MHz
• Manufacturer: NXP Semiconductors

NXP Semiconductors
LPC111X
Product data sheet
9.4 Power consumption LPC1100XL series
(LPC111x/103/203/303/323/333)
Power measurements in Active, Sleep, and Deep-sleep modes were performed under the
following conditions (see LPC111x user manual):
Fig 26. Active mode: Typical supply current I
•
•
•
Configure all pins as GPIO with pull-up resistor disabled in the IOCONFIG block.
Configure GPIO pins as outputs using the GPIOnDIR registers.
Write 0 to all GPIOnDATA registers to drive the outputs LOW.
(mA)
I
DD
Conditions: T
disabled in the SYSAHBCLKCTRL register (SYSAHBCLKCTRL = 0x1F); all peripheral clocks
disabled; internal pull-up resistors disabled; BOD disabled; low-current mode.
3 MHz - 6 MHz: system oscillator enabled; PLL, IRC disabled.
12 MHz: IRC enabled; system oscillator, PLL disabled.
24 MHz - 48 MHz: IRC disabled; system oscillator, PLL enabled.
system clock frequencies (for LPC111x/103/203/303/323/333)
8
6
4
2
0
1.8
All information provided in this document is subject to legal disclaimers.
amb
= 25 C; active mode entered executing code
Rev. 7 — 1 March 2012
2.1
2.4
LPC1110/11/12/13/14/15
DD
2.7
48 MHz
36 MHz
24 MHz
12 MHz
6 MHz
3 MHz
versus supply voltage V
32-bit ARM Cortex-M0 microcontroller
3
while(1){}
from flash; all peripherals
3.3
V
DD
© NXP B.V. 2012. All rights reserved.
DD
(V)
002aag922
for different
3.6
66 of 103