SAM9263 Atmel Corporation, SAM9263 Datasheet - Page 93

• Manufacturer Part Number: SAM9263
• Manufacturer: Atmel Corporation

Specifications of SAM9263

• Flash (kbytes): 0 Kbytes
• Pin Count: 324
• Max. Operating Frequency: 240 MHz
• Cpu: ARM926
• Hardware Qtouch Acquisition: No
• Max I/o Pins: 160
• Ext Interrupts: 160
• Usb Transceiver: 3
• Usb Speed: Full Speed
• Usb Interface: Host, Device
• Spi: 2
• Twi (i2c): 1
• Uart: 4
• Can: 1
• Ssc: 2
• Ethernet: 1
• Sd / Emmc: 2
• Graphic Lcd: Yes
• Video Decoder: No
• Camera Interface: Yes
• Resistive Touch Screen: No
• Temp. Sensor: No
• Crypto Engine: No
• Sram (kbytes): 96
• Self Program Memory: NO
• External Bus Interface: 2
• Dram Memory: sdram
• Nand Interface: Yes
• Picopower: No
• Temp. Range (deg C): -40 to 85
• I/o Supply Class: 1.8/3.3
• Fpu: No
• Mpu / Mmu: No / Yes
• Timers: 3
• Output Compare Channels: 3
• Input Capture Channels: 3
• Pwm Channels: 4
• 32khz Rtc: Yes
• Calibrated Rc Oscillator: No

WD Enabling Sequence
1354D–ATARM–08/02
To enable the Watchdog Timer the sequence is as follows:
1. Disable the Watchdog by clearing the bit WDEN:
2. Initialize the WD Clock Mode Register:
3. Restart the timer:
4. Enable the watchdog:
Write 0x2340 to WD_OMR
This step is unnecessary if the WD is already disabled (reset state).
Write 0x373C to WD_CMR
(HPCV = 15 and WDCLKS = MCK/8)
Write 0xC071 to WD_CR
Write 0x2345 to WD_OMR (interrupt enabled)
AT91X40 Series
93