SAM7SE32 Atmel Corporation, SAM7SE32 Datasheet - Page 41

• Manufacturer Part Number: SAM7SE32
• Manufacturer: Atmel Corporation

Specifications of SAM7SE32

• Flash (kbytes): 32 Kbytes
• Pin Count: 144
• Max. Operating Frequency: 48 MHz
• Cpu: ARM7TDMI
• Hardware Qtouch Acquisition: No
• Max I/o Pins: 88
• Ext Interrupts: 88
• Usb Transceiver: 1
• Usb Speed: Full Speed
• Usb Interface: Device
• Spi: 1
• Twi (i2c): 1
• Uart: 3
• Ssc: 1
• Graphic Lcd: No
• Video Decoder: No
• Camera Interface: No
• Adc Channels: 8
• Adc Resolution (bits): 10
• Adc Speed (ksps): 384
• Resistive Touch Screen: No
• Temp. Sensor: No
• Crypto Engine: No
• Sram (kbytes): 8
• Self Program Memory: NO
• External Bus Interface: 1
• Dram Memory: sdram
• Nand Interface: Yes
• Picopower: No
• Temp. Range (deg C): -40 to 85
• I/o Supply Class: 1.8/3.3
• Operating Voltage (vcc): 3.0 to 3.6
• Fpu: No
• Mpu / Mmu: Yes / No
• Timers: 3
• Output Compare Channels: 3
• Input Capture Channels: 3
• Pwm Channels: 4
• 32khz Rtc: Yes
• Calibrated Rc Oscillator: No

10.11 Timer Counter
10.12 PWM Controller
6222ES–ATARM–15-Dec-09
Table 10-4.
• Offers a configurable frame sync and data length
• Receiver and transmitter can be programmed to start automatically or on detection of
• Receiver and transmitter include a data signal, a clock signal and a frame synchronization
• Three 16-bit Timer Counter Channels
• Wide range of functions including:
• Each channel is user-configurable and contains:
• Four channels, one 16-bit counter per channel
• Common clock generator, providing thirteen different clocks
• Independent channel programming
different event on the frame sync signal
signal
– Two output compare or one input capture per channel
– Frequency measurement
– Event counting
– Interval measurement
– Pulse generation
– Delay timing
– Pulse Width Modulation
– Up/down capabilities
– Three external clock inputs
– Five internal clock inputs, as defined in
– Two multi-purpose input/output signals
– Two global registers that act on all three TC channels
– One Modulo n counter providing eleven clocks
– Two independent linear dividers working on modulo n counter outputs
– Independent enable/disable commands
– Independent clock selection
– Independent period and duty cycle, with double buffering
– Programmable selection of the output waveform polarity
– Programmable center or left aligned output waveform
Timer Counter Clocks Assignment
TIMER_CLOCK1
TIMER_CLOCK2
TIMER_CLOCK3
TIMER_CLOCK4
TIMER_CLOCK5
TC Clock input
AT91SAM7SE512/256/32 Summary
Table 10-4
MCK/1024
MCK/128
MCK/32
MCK/2
MCK/8
Clock
41