SAM7SE32 Atmel Corporation, SAM7SE32 Datasheet - Page 19

• Manufacturer Part Number: SAM7SE32
• Manufacturer: Atmel Corporation

Specifications of SAM7SE32

• Flash (kbytes): 32 Kbytes
• Pin Count: 144
• Max. Operating Frequency: 48 MHz
• Cpu: ARM7TDMI
• Hardware Qtouch Acquisition: No
• Max I/o Pins: 88
• Ext Interrupts: 88
• Usb Transceiver: 1
• Usb Speed: Full Speed
• Usb Interface: Device
• Spi: 1
• Twi (i2c): 1
• Uart: 3
• Ssc: 1
• Graphic Lcd: No
• Video Decoder: No
• Camera Interface: No
• Adc Channels: 8
• Adc Resolution (bits): 10
• Adc Speed (ksps): 384
• Resistive Touch Screen: No
• Temp. Sensor: No
• Crypto Engine: No
• Sram (kbytes): 8
• Self Program Memory: NO
• External Bus Interface: 1
• Dram Memory: sdram
• Nand Interface: Yes
• Picopower: No
• Temp. Range (deg C): -40 to 85
• I/o Supply Class: 1.8/3.3
• Operating Voltage (vcc): 3.0 to 3.6
• Fpu: No
• Mpu / Mmu: Yes / No
• Timers: 3
• Output Compare Channels: 3
• Input Capture Channels: 3
• Pwm Channels: 4
• 32khz Rtc: Yes
• Calibrated Rc Oscillator: No

7.6
7.7
6222ES–ATARM–15-Dec-09
SDRAM Controller
Error Corrected Code Controller
• Multiple device adaptability
• Multiple Wait State Management
• Numerous configurations supported
• Programming facilities
• Energy-saving capabilities
• Error detection
• SDRAM Power-up Initialization by software
• Latency is set to two clocks (CAS Latency of 1, 3 Not Supported)
• Auto Precharge Command not used
• Mobile SDRAM supported (except for low-power extended mode and deep power-down
• Tracking the accesses to a NAND Flash device by triggering on the corresponding chip select
• Single bit error correction and 2-bit Random detection.
• Automatic Hamming Code Calculation while writing
• Automatic Hamming Code Calculation while reading
mode)
– Compliant with LCD Module
– Compliant with PSRAM in synchronous operations
– Programmable Setup Time Read/Write
– Programmable Hold Time Read/Write
– Programmable Wait State Generation
– External Wait Request
– Programmable Data Float Time
– 2K, 4K, 8K Row Address Memory Parts
– SDRAM with two or four Internal Banks
– SDRAM with 16- or 32-bit Data Path
– Word, half-word, byte access
– Automatic page break when Memory Boundary has been reached
– Multibank Ping-pong Access
– Timing parameters specified by software
– Automatic refresh operation, refresh rate is programmable
– Self-refresh, and Low-power Modes supported
– Refresh Error Interrupt
– ECC value available in a register
– Error Report, including error flag, correctable error flag and word address being
– Supports 8- or 16-bit NAND Flash devices with 512-, 1024-, 2048- or 4096-byte
detected erroneous
pages
AT91SAM7SE512/256/32 Summary
19