TDA8595TH/N2C,118 NXP Semiconductors, TDA8595TH/N2C,118 Datasheet - Page 13

• Manufacturer Part Number: TDA8595TH/N2C,118
• Description: IC AMP AUDIO PWR 64W QUAD 36HSOP
• Manufacturer: NXP Semiconductors
• Type: Class ABr

Specifications of TDA8595TH/N2C,118

• Output Type: 4-Channel (Quad)
• Max Output Power X Channels @ Load: 64W x 4 @ 2 Ohm
• Voltage - Supply: 8 V ~ 18 V
• Features: Depop, I²C, Mute, Short-Circuit and Thermal Protection, Standby
• Mounting Type: Surface Mount
• Package / Case: 36-HSOP
• Product: Class-AB
• Operational Class: Class-AB
• Audio Amplifier Output Configuration: 4-Channel Stereo
• Output Power (typ): 25x4@4OhmW
• Audio Amplifier Function: Speaker
• Total Harmonic Distortion: 0.14@4Ohm@12W%
• Single Supply Voltage (typ): 14.4V
• Dual Supply Voltage (typ): Not RequiredV
• Power Supply Requirement: Single
• Power Dissipation: 80W
• Rail/rail I/o Type: No
• Single Supply Voltage (min): 8V
• Single Supply Voltage (max): 18V
• Dual Supply Voltage (min): Not RequiredV
• Dual Supply Voltage (max): Not RequiredV
• Operating Temp Range: -40C to 105C
• Operating Temperature Classification: Industrial
• Mounting: Surface Mount
• Pin Count: 36
• Package Type: HSOP
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant, Lead free / RoHS Compliant
• Other names: 935284654118; TDA8595TH/N2C-T; TDA8595TH/N2C-T

NXP Semiconductors
TDA8595_2
Product data sheet
When the SVR capacitor has discharged, the amplifier starts up again if the V
above the low V
outputs of the amplifier remain low. In I
typically 5 V, results in setting bit DB2[D7]. The amplifiers will not start-up but wait for an
I
The amplifier prevents audio pops during engine start. To prevent pops on the output
caused by the application during an engine start (for instance tuner regulator out of
regulation), the STB pin can be made zero when an engine start is detected. The STB pin
activates the fast mute and disturbances at the amplifier inputs are suppressed.
2
Fig 8. Low headroom protection
C-bus command to start-up.
(1) Headroom voltage V
(2) Steady state output voltage V
(3) Headroom protection threshold = V
8.4
(V)
14
V
7
P
V
V
V
P
SVR
O
mute threshold, typically 7.5 V. Below the low V
(2)
Rev. 02 — 21 November 2007
hr
= V
P
O
V
O
= V
.
SVR
O
2
+ 1.6 V.
C-bus mode, a supply voltage drop below V
V
1.4 V.
hr
I
(1)
2
C-bus controlled 4
headroom protection
P
threshold
mute threshold, the
45 W power amplifier
TDA8595
© NXP B.V. 2007. All rights reserved.
(3)
001aad172
1.6 V
t (s)
P
voltage is
P(reset)
13 of 50
,