STLED316SMTR STMicroelectronics, STLED316SMTR Datasheet - Page 12

• Manufacturer Part Number: STLED316SMTR
• Description: IC LED CTLR SERIAL 6DIGIT SO-24
• Manufacturer: STMicroelectronics

Specifications of STLED316SMTR

• Applications: LED Controller with Keyscan, 6-Digit
• Interface: Serial
• Voltage - Supply: 4.5 V ~ 5.5 V
• Package / Case: 24-SOIC (7.5mm Width)
• Mounting Type: Surface Mount
• Number Of Digits: 6
• Number Of Segments: 48
• Operating Supply Voltage: 4.5 V to 5.5 V
• Maximum Supply Current: 15000 uA
• Maximum Power Dissipation: 1200 mW
• Maximum Operating Temperature: + 85 C
• Mounting Style: SMD/SMT
• Minimum Operating Temperature: - 40 C
• For Use With: 497-8417 - BOARD DEMO FRONT PANEL STLED316S497-8399 - BOARD EVAL ST7LITE49M/STLED316S497-8432 - BOARD LED CTLR/DVR STLED316S
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 497-6925-2; STLED316SMTR

STLED316S functional description
3.8
3.9
3.10
12/33
LED drivers
The constant current capability is up to 40 mA per output segment and is set for all the
outputs using a single external resistor. When acting as digit drivers, the outputs source
current to the display anodes. When acting as segment drivers, the LED outputs sink current
from the display cathodes. The outputs are high impedance when not being used as digit or
segment drivers.
Each port configured as a LED digit driver behaves as a digitally-controlled constant current
sink. The LED drivers are suitable for both discrete LEDs and common anode (CA) numeric
LED digits. When fully configured as a LED driver, the STLED316S controls up to 8 LED
segments in a single digit with 8-step logarithmic brightness control for the digits. A single
resistor sets the maximum segment current for all the segments, with a maximum of 40mA
per segment. The STLED316S drives any combination of discrete LEDs and CA digits for
numeric displays.
The recommended value of R
driver to the maximum allowed segment current. R
segment current to a lower maximum value where desired. The user must also ensure that
the maximum current specifications of the LEDs connected to the drivers are not exceeded.
The brightness of the individual digits in the display panel can be controlled separately.
Interrupt
The device includes an active low level IRQ_N pin to the microprocessor. The STLED316S
generates an interrupt when a key is pressed.
Operating the device with 3.3 V interface voltages
The device can detect the input voltage levels reference to 3.3 V from the main controller
chip as long as the V
voltage to STLED316S is greater than 2.9 V, the STLED316S will recognize the signal level
as a valid high and if the input voltage is lower than 1.75 V, it will be recognized as a valid
low level.
For the output signals from the device like DOUT and IRQ_N, the signal level depends on
the external supply to which the external pull up resistor is connected to. Thus this
eliminates the use of any level shifter between the main controller and the STLED316S.
IL
and V
IH
SET
specifications of the STLED316S are met. If the input
is the minimum allowed value, since it sets the display
SET
can be a higher value to set the
STLED316S