SAB-C161PI-L25F CA Infineon Technologies, SAB-C161PI-L25F CA Datasheet - Page 42

• Manufacturer Part Number: SAB-C161PI-L25F CA
• Description: Microcontrollers (MCU) 16BIT SNGL CHIP 5V 25MHz ROM less
• Manufacturer: Infineon Technologies

Specifications of SAB-C161PI-L25F CA

• Data Bus Width: 16 bit
• Program Memory Type: ROMLess
• Data Ram Size: 3 KB
• Interface Type: ASC, I2C, SSC
• Maximum Clock Frequency: 25 MHz
• Number Of Programmable I/os: 76
• Number Of Timers: 5
• Maximum Operating Temperature: + 70 C
• Mounting Style: SMD/SMT
• Package / Case: TQFP-100
• Minimum Operating Temperature: 0 C
• On-chip Adc: 10 bit, 4 Channel
• Packages: PG-TQFP-100
• Max Clock Frequency: 25.0 MHz
• Sram (incl. Cache): 3.0 KByte
• A / D Input Lines (incl. Fadc): 4
• Program Memory: 0.0 KByte
• Lead Free Status / Rohs Status: Details
• Other names: B161PIL25FCAXT

Data Sheet
DC Characteristics (Standard Supply Voltage Range) (continued)
(Operating Conditions apply)
Parameter
Power-down mode supply
current (5V) with RTC running
Power-down mode supply
current (5V) with RTC disabled
1) This specification is not valid for outputs which are switched to open drain mode. In this case the respective
2) These parameters describe the RSTIN pullup, which equals a resistance of ca. 50 to 250 K .
3) The maximum current may be drawn while the respective signal line remains inactive.
4) The minimum current must be drawn in order to drive the respective signal line active.
5) This specification is only valid during Reset, or during Hold- or Adapt-mode. During Hold mode Port 6 pins are
6) Not 100% tested, guaranteed by design characterization.
7) The supply current is a function of the operating frequency. This dependency is illustrated in the figure below.
8) This parameter is determined mainly by the current consumed by the oscillator. This current, however, is
9) This parameter is tested including leakage currents. All inputs (including pins configured as inputs) at 0 V to
output will float and the voltage results from the external circuitry.
only affected, if they are used (configured) for CS output and the open drain function is not enabled.
These parameters are tested at
at
The oscillator also contributes to the total supply current. The given values refer to the worst case, ie. I
For lower oscillator frequencies the respective supply current can be reduced accordingly.
influenced by the external oscillator circuitry (crystal, capacitors). The values given refer to a typical circuitry
and may change in case of a not optimized external oscillator circuitry.
0.1 V or at
IL
or
IH
.
DD
– 0.1 V to
DD
,
REF
DDmax
= 0 V, all outputs (including pins configured as outputs) disconnected.
and maximum CPU clock with all outputs disconnected and all inputs
Symbol
PDR5
PDO5
8)
40
–
–
min.
Limit Values
200 +
25*
50
max.
OSC
Unit Test Condition
A
A
OSC
DD
DD
=
=
in [MHz]
DDmax
DDmax
&3,
1999-07
PDRmax
9)
9)
.