C2234SW 3M, C2234SW Datasheet - Page 13

• Manufacturer Part Number: C2234SW
• Description: LCD Touch Panels 22 C2234SW 1680x1050 Cap Touch
• Manufacturer: 3M
• Series: -r
• Type: Capacitiver

Specifications of C2234SW

• Length: 18.6" (473.8mm)
• Width: 19.7" (500mm)
• Height: 11.6" (296.1mm)
• Interface: USB/Serial
• Diagonal Screen Size: 22" (559mm)
• Lead Free Status / Rohs Status: Details

3M™ MicroTouch™ Chassis Display User Guide
Testing the SCT Chassis Display
Mounting the SCT Chassis Display
To connect the SCT Chassis Display:
1. Turn off your computer. You should always turn off the computer before connecting
2. Select either the DVI or VGA cable. Connect one end of the video cable to the video
3. Connect one end of the touch sensor cable (either USB or serial) to the LCD.
4. Plug the power brick into the display.
5. Connect the power cable to an appropriate grounded power source.
Note: The SCT Chassis Display has a power status light and video controls located on
the back of the display. If enclosure space is tight and access is important, an on screen
display remote control (part number 30114) is an option.
Before testing your touch display, make sure all cables are connected properly. Be sure to
tighten all cable screws. After connection, turn on the power switch located on the back
of the display.
To test that the display is working properly:
1. Turn on your computer.
2. Make sure the video image is displayed.
3. Make sure the video image is centered within the screen area. Use the display
Note: If you are having difficulties with your display, refer to the troubleshooting guide
in Appendix A for additional assistance.
You can adjust the horizontal and vertical position, contrast, and brightness to better suit
your video card and your personal preference. For additional details, refer to the
Adjusting the Video Display later in this chapter.
The SCT Chassis Display is designed to fit any type of enclosure. All 3M Touch Systems
chassis displays are encased in rugged metal instead of plastic, making them easy to
integrate.
The SCT Chassis Display includes a hardware accessory kit for mounting the unit into an
enclosure. The SCT Chassis Display hardware accessory kit includes four brackets and 8
screws. The mounting holes are located on all 4 sides of the display. Always use the
supplied screws (M4 x 8 mm).
or disconnecting a device.
connector on the display. Connect the other end to the video card in your computer.
Connect the other end to an available port on your computer.
Note: Do not connect both USB and serial cables to the display. Choose one or the
other.
controls to adjust the image, if necessary.
3M Touch Systems, Inc. Proprietary Information -- 37762v01
13