LPC2194HBD64/01-S NXP Semiconductors, LPC2194HBD64/01-S Datasheet - Page 17

• Manufacturer Part Number: LPC2194HBD64/01-S
• Description: MCU 16-Bit/32-Bit LPC2000 ARM7TDMI-S RISC 256KB Flash 1.8V/3.3V 64-Pin LQFP Tray
• Manufacturer: NXP Semiconductors

Specifications of LPC2194HBD64/01-S

• Package: 64LQFP
• Device Core: ARM7TDMI-S
• Family Name: LPC2000
• Maximum Speed: 60 MHz
• Ram Size: 16 KB
• Program Memory Size: 256 KB
• Operating Supply Voltage: 1.8|3.3 V
• Data Bus Width: 16|32 Bit
• Program Memory Type: Flash
• Number Of Programmable I/os: 46
• Interface Type: CAN/I2C/SPI/SSP/UART
• On-chip Adc: 4-chx10-bit
• Operating Temperature: -40 to 125 °C
• Number Of Timers: 2

NXP Semiconductors
LPC2194_5
Product data sheet
6.14.1 Features
6.14.2 Features available in LPC2194/01 only
6.15.1 Features
6.15 Watchdog timer
The LPC2194/01 can count external events on one of the capture inputs if the external
pulse lasts at least one half of the period of the PCLK. In this configuration, unused
capture lines can be selected as regular timer capture inputs, or used as external
interrupts.
The purpose of the watchdog is to reset the microcontroller within a reasonable amount of
time if it enters an erroneous state. When enabled, the watchdog will generate a system
reset if the user program fails to ‘feed’ (or reload) the watchdog within a predetermined
amount of time.
•
•
•
•
•
•
•
•
•
•
•
A 32-bit Timer/Counter with a programmable 32-bit Prescaler.
Timer or external event counter operation
Four 32-bit capture channels per timer that can take a snapshot of the timer value
when an input signal transitions. A capture event may also optionally generate an
interrupt.
Four 32-bit match registers that allow:
– Continuous operation with optional interrupt generation on match.
– Stop timer on match with optional interrupt generation.
– Reset timer on match with optional interrupt generation.
Four external outputs per timer corresponding to match registers, with the following
capabilities:
– Set LOW on match.
– Set HIGH on match.
– Toggle on match.
– Do nothing on match.
Timer can count cycles of either the peripheral clock (PCLK) or an externally supplied
clock.
When counting cycles of an externally supplied clock, only one of the timer’s capture
inputs can be selected as the timer’s clock. The rate of such a clock is limited to
PCLK / 4. Duration of HIGH/LOW levels on the selected CAP input cannot be shorter
than 1 / (2PCLK).
Internally resets chip if not periodically reloaded.
Debug mode.
Enabled by software but requires a hardware reset or a watchdog reset/interrupt to be
disabled.
Incorrect/incomplete feed sequence causes reset/interrupt if enabled.
Rev. 05 — 10 December 2007
Single-chip 16/32-bit microcontroller
LPC2194
© NXP B.V. 2007. All rights reserved.
17 of 40