PIC18F26K80-I/SO Microchip Technology Inc., PIC18F26K80-I/SO Datasheet - Page 291

• Manufacturer Part Number: PIC18F26K80-I/SO
• Description: IC, MCU, nanoWatt; 8-bit w/ECAN; Flash, 64KB; 16MIPS; 8-ch, 12-BIT A/D; SOIC-28
• Manufacturer: Microchip Technology Inc.

Specifications of PIC18F26K80-I/SO

• A/d Inputs: 8-Channel, 12-Bit
• Comparators: 2
• Cpu Speed: 16 MIPS
• Eeprom Memory: 256 Bytes
• Input Output: 24
• Interface: I2C/SPI/UART/USART
• Memory Type: Flash
• Number Of Bits: 8
• Package Type: 28-pin SOIC
• Programmable Memory: 64K Bytes
• Ram Size: 3.6K Bytes
• Speed: 64 MHz
• Temperature Range: –40 to 125 °C
• Timers: 2-8-bit, 3-16-bit
• Voltage, Range: 1.8-5.5 V
• Lead Free Status / Rohs Status: RoHS Compliant part

20.4.8
In Sleep mode, all clock sources are disabled. Timer2/4
will not increment and the state of the module will not
change. If the ECCP1 pin is driving a value, it will con-
tinue to drive that value. When the device wakes up, it
will continue from this state. If Two-Speed Start-ups are
enabled, the initial start-up frequency from HF-INTOSC
and the postscaler may not be stable immediately.
In PRI_IDLE mode, the primary clock will continue to
clock the ECCP1 module without change.
 2011 Microchip Technology Inc.
OPERATION IN POWER-MANAGED
MODES
Preliminary
PIC18F66K80 FAMILY
20.4.8.1
If the Fail-Safe Clock Monitor (FSCM) is enabled, a clock
failure will force the device into the power-managed
RC_RUN mode and the OSCFIF bit of the PIR2 register
will be set. The ECCP1 will then be clocked from the
internal oscillator clock source, which may have a
different clock frequency than the primary clock.
20.4.9
Both Power-on Reset and subsequent Resets will force
all ports to Input mode and the ECCP registers to their
Reset states.
This forces the ECCP module to reset to a state
compatible with previous, non-enhanced CCP modules
used on other PIC18 and PIC16 devices.
EFFECTS OF A RESET
Operation with Fail-Safe
Clock Monitor (FSCM)
DS39977C-page 291