ATA6621N-PGPW Atmel, ATA6621N-PGPW Datasheet - Page 13

• Manufacturer Part Number: ATA6621N-PGPW
• Description: TXRX LIN 5V REG WATCHDOG 20-QFN
• Manufacturer: Atmel
• Type: Transceiverr

Specifications of ATA6621N-PGPW

• Number Of Drivers/receivers: 1/1
• Protocol: LIN
• Voltage - Supply: 5 V ~ 18 V
• Mounting Type: Surface Mount
• Package / Case: 20-QFN Exposed Pad
• Number Of Transmitters: 1
• Number Of Receivers: 1
• Power Supply Requirement: Single
• Package Type: QFN EP
• Operating Temperature Classification: Automotive
• Mounting: Surface Mount
• Pin Count: 20
• Operating Temperature (max): 125C
• Operating Temperature (min): -40C
• Dual Supply Voltage (typ): Not RequiredV
• Dual Supply Voltage (max): Not RequiredV
• Dual Supply Voltage (min): Not RequiredV
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

3.18
4887I–AUTO–09/09
Voltage Regulator
The voltage regulator needs an external capacitor for compensation and to smooth the distur-
bances from the microcontroller. It is recommend to use an tantalum capacitor with C > 10 µF
and a ceramic capacitor with C = 100 nF. The values of these capacitors can be varied by the
customer, depending on the application.
During mode change from Silent to Normal mode, the voltage regulator ramps up to 6V for only
a few microseconds before it drops back to 5V. This behavior depends on the value of the load
capacitor. With 4.7 µF, the overshoot voltage has its greatest value. This voltage decreases with
higher or lower load capacitors.
The main power dissipation of the IC is created from the V
needed for the application.
In
Figure 3-7.
• If the WD_OSC pin has a short circuit to GND or the resistor is disconnected, the watchdog
• The WD_OSC pin is a constant voltage regulator which supplies 2.5V for the external resistor
Figure 3-8 on page 14
oscillator runs with a high frequency and guarantees a reset. In order to activate this feature
in any condition it is recommended to enter the Silent mode (via the Normal mode) directly
after power up.
ROSC to adjust the watchdog timing. This output is short circuit protected. A short circuit to
GND causes a reset a pin NRES after typically 4 ms. An open circuit causes a reset at pin
NRES after typically 7 ms.
NRES
VCC
VS
V
5.5V
12V
thun
3V
5V
5V
VCC Voltage Regulator: Ramp Up and Undervoltage
you see the safe operating range of the ATA6621N.
t
vcc
t
res
CC
output current I
t
res_f
ATA6621N
VCC
, which is
t
t
t
13