ES-UA-5A BANNER ENGINEERING, ES-UA-5A Datasheet - Page 17

• Manufacturer Part Number: ES-UA-5A
• Description: Sensor, E-stop Module, output 6A,
• Manufacturer: BANNER ENGINEERING
• Type: Safetyr

Specifications of ES-UA-5A

• Contact Form: 4-NO/1-NC
• Dimensions: 45mmW×84mmH×118mmD
• Enclosure Rating: IP20
• Ip Rating: IP20
• Mounting Type: DIN Rail
• Number Of Outputs: 8
• Output Type: Relay
• Power, Rating: 4 W
• Primary Type: Controller
• Standards: UL, CSA, CE
• Voltage, Supply: 115/12 to 24 VAC/VDC
• Coil Voltage Vdc Nom: 24V
• Coil Resistance: 250ohm
• Contact Current Max: 6A
• Contact Voltage Ac Nom: 24V
• Contact Voltage Dc Nom: 250V
• Contact Configuration: SPST-NC
• No. Of Poles: 1
• Relay Mounting: DIN Rail
• Lead Free Status / Rohs Status: RoHS Exempt Product
• For Use With: Emergency Stop

ES-UA-5A and ES-VA-5A E-Stop Safety Modules
P/N 122365 rev. C
Condition
Fault
Fault
Fault
Fault
MSCs do not energize
Banner Engineering Corp. - Minneapolis, MN USA - www.bannerengineering.com
Indicator Status
Ch1 LED ON
Ch2 LED OFF
Power LED ON
Fault LED ON*
Ch1 and Ch2 LED flashing alter-
nately
Power LED ON
Fault LED ON*
Ch1 LED OFF
Ch2 LED Flashing
Power LED ON
Fault LED ON*
Ch1 LED Flashing
Ch2 LED OFF
Power LED ON
Fault LED ON*
Ch2 LED ON
Ch1 LED ON
All LEDs OFF
Dim LEDs
*Fault LED Flickers
Power LED ON
Fault LED OFF
Ch1 LED ON
Ch2 LED ON
Tel: [phone]
Possible Causes / Solutions
Input concurrency fault: Both inputs did not open
concurrently. Both inputs are now closed.
Input concurrency fault: Ch1 opened and closed and
is now open while Ch2 remained closed.
Input concurrency fault: Ch1 remained closed while
Ch2 opened and closed and is now open.
Possible input fault: Ch1 and Ch 2 are closed and are
(or were) shorted together.
Possible internal fault:
Possible fault in machine control or wiring to mod-
ule:
Dim Power LED:
Other LEDs dim:
This is normal while the Fault LED is ON.
Possible fault in machine control or an open circuit
between machine control and MSCs:
Check switch.
Check connectors are properly seated.
Check switches/wiring at both inputs.
Open both inputs to clear the fault.
Check switches/wiring at both inputs.
Open both inputs to clear the fault.
Check switches/wiring at both inputs.
Open both inputs to clear the fault .
Check wiring at both inputs.
Open both inputs to clear the fault.
Return to factory for repair or replacement
Check input power connections or external fuses.
Check connectors are properly seated.
Check power supply capacity and load.
May glow during power-up (normal).
Check power supply load and capacity.
Check continuity of safety outputs (e.g. between termi-
nals 13 and 14).
Check control wires and connectors.
Check MSCs.
17