ES-FA-9AA BANNER ENGINEERING, ES-FA-9AA Datasheet - Page 11

• Manufacturer Part Number: ES-FA-9AA
• Description: Module; Relay; Red LED; 24; UL Listed
• Manufacturer: BANNER ENGINEERING

Specifications of ES-FA-9AA

• Light Source: Red LED
• Coil Voltage Vac Nom: 24V
• Coil Voltage Vdc Nom: 24V
• Contact Current Max: 6A
• Contact Voltage Ac Nom: 250V
• Contact Voltage Dc Nom: 250V
• Contact Configuration: 3PST-NO
• No. Of Poles: 3
• Lead Free Status / Rohs Status: RoHS Exempt Product

Supply Voltage and Current
Supply Protection Circuitry
Output Configuration
Output Response Time
Input Requirements
Minimum OFF-State
Recovery Time
Indicators
Construction
Mounting
Vibration Resistance
Operating Conditions
Dimensions
Banner Engineering Corp.
www.bannerengineering.com • Tel: [phone]
•
Minneapolis, MN U.S.A.
24V ac/dc, +/- 10%; 50/60Hz
Power consumption: approx. 2W/2VA
Protected against transient voltages and reverse polarity
3 normally open (N/O) output channels
Each normally open output channel is a series connection of contacts from two forced-guided (positive-guided)
relays, K1-K2.
Contacts: AgNi, 5 µm gold-plated
Low Current Rating:
Caution: The  µm gold-plated contacts allow the switching of low current/low voltage. In these low-power
To preserve the gold plating on the contacts, the following max. values should not be exceeded at any time:
High Current Rating:
If higher loads must be switched through one or more of the contacts, the minimum and maximum values of the
contact(s) changes to:
Mechanical life: 50,000,000 operations
Electrical life: 150,000 operations (typical, @ 200 W (1,500 VA) switched power, resistive load
Note: Transient suppression is recommended when switching inductive loads. Install suppressors across load.
25 milliseconds typical
E-stop switch must have one or two normally closed contacts capable of switching 40 to 100mA @ 13 to
27V ac/dc.
Reset switch must have one normally open contact capable of switching 20 to 30mA @ 13 to 27V ac/dc.
250 ms
 green LED indicators:
Power ON
K1 energized
K2 energized
Polycarbonate housing. Rated NEMA 1; IEC IP40, Terminals IP20
Mounts to standard 35 mm DIN rail track. Safety Module must be installed inside an enclosure rated
NEMA 3 (IEC IP54), or better.
10 to 55Hz @ 0.35mm displacement per IEC 68-2-6
Temperature: 0° to +50°C (+32° to 122°F)
Max. Relative Humidity: 90% @ +50°C (non-condensing)
See Figure 6.
Min. voltage: 1V ac/dc
Min. current: 5 mA ac/dc
Min. power: 5 mW (5 mVA)
Min. voltage: 15V ac/dc
Min. current: 250 mA ac/dc
Min. power: 5 W (5 VA)
Never install suppressors across output contacts (see Warning, page ).
applications, multiple contacts can also be switched in series (e.g., “dry switching”).
Specifications
E-Stop Safety Module –
Max. voltage: 60V
Max. current: 300 mA
Max. power: 7 W (7 VA)
Max. voltage: 250V ac/dc
Max. current: 6 A
Max. power: 200 W (1,500 VA)
ES-FA-9AA
P/N 60606 rev. B
11