EMC1423-1-AIZLTR SMSC, EMC1423-1-AIZLTR Datasheet - Page 19

• Manufacturer Part Number: EMC1423-1-AIZLTR
• Description: Board Mount Temperature Sensors TRIPLE TEMP SNSR
• Manufacturer: SMSC

Specifications of EMC1423-1-AIZLTR

• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

1°C Temperature Sensor with Hardware Thermal Shutdown
Datasheet
SMSC EMC1423/EMC1424
5.1
CONVERSION RATE
CONVERSION RATE
4 / sec (default)
32 / sec
64 / sec
16 / sec
32 / sec
64 / sec
1 / sec
2 / sec
8 / sec
When enabled, the dynamic averaging will affect the average supply current based on the chosen
conversion rate as shown in
The SYS_SHDN output is asserted independently of the ALERT output and cannot be masked. If the
External Diode 1 temperature exceeds the Hardware Thermal Shutdown Limit for the programmed
number of consecutive measurements, then the SYS_SHDN pin is asserted.
The Hardware Thermal Shutdown Limit is defined at power-up via the pull-up resistors on the
SYS_SHDN and ALERT pins as shown in
software.
In addition to External Diode 1 channel triggering the SYS_SHDN pin when the measured temperature
exceeds to the Hardware Thermal Shutdown Limit, each of the measurement channels can be
configured to assert the SYS_SHDN pin when they exceed the corresponding THERM Limit.
When the SYS_SHDN pin is asserted, it will not release until the External Diode 1 temperature drops
below the Hardware Thermal Shutdown Limit minus 10°C and all other measured temperatures drop
below the THERM Limit minus the THERM Hysteresis value (when linked to SYS_SHDN).
Figure 5.3
pin.
SYS_SHDN Output
Table 5.1 Supply Current vs. Conversion Rate for EMC1423 (continued)
shows a block diagram of the interaction between the input channels and the SYS_SHDN
Table 5.2 Supply Current vs. Conversion Rate for EMC1424
AVERAGE SUPPLY CURRENT
(DEFAULT)
ENABLED
(DEFAULT)
ENABLED
1010uA
1020uA
1050uA
1100uA
AVERAGE SUPPLY CURRENT
660uA
930uA
950uA
1050uA
1100uA
Table 5.2
DATASHEET
for EMC1424.
DISABLED
1050uA
1100uA
19
430uA
475uA
510uA
630uA
775uA
DISABLED
Table
1050uA
1100uA
5.3. This limit cannot be modified or masked via
AVERAGING FACTOR (BASED ON 11-BIT
(DEFAULT)
ENABLED
AVERAGING FACTOR (BASED ON
0.125x
0.25x
(DEFAULT)
0.5x
ENABLED
8x
4x
2x
1x
0.25x
0.5x
11-BIT OPERATION)
OPERATION)
Revision 1.36 (07-02-09)
DISABLED
DISABLED
0.125x
0.25x
0.5x
0.25x
0.5x
1x
1x
1x
1x