N80960SA10 Intel, N80960SA10 Datasheet - Page 38

• Manufacturer Part Number: N80960SA10
• Description: IC MPU I960SA 10MHZ 84-PLCC
• Manufacturer: Intel

Specifications of N80960SA10

• Rohs Status: RoHS non-compliant
• Processor Type: i960
• Features: SA suffix, 32-Bit, 512 Byte Cache
• Speed: 10MHz
• Voltage: 5V
• Mounting Type: Surface Mount
• Package / Case: 84-PLCC
• Other names: 803819

80960SA
5.0
This data sheet supersedes data sheet 272206-001 and applies only to those devices identified as the current
stepping in section 3.5. The sections significantly changed since the previous revision are:
Data sheet 270917-004 applied to both the 80960SA and the 80960SB. The 80960SA was then documented
alone in data sheet 272206-001. The sections significantly changed between revisions -004 of the SA/SB data
sheet and 272206-001 of the SA data sheet were:
34
2.3 Connection Recommendations (pg. 11)
2.5 Test Load Circuit (pg. 13)
2.7 DC Characteristics (pg. 14)
3.5 Stepping Register Information (pg. 27)
2.3 Connection Recommendations
(pg. 11)
Figure 6. Typical Supply Current vs.
Case Temperature (pg. 11)
Figure 7. Typical Current vs. Fre-
quency (Room Temp) (pg. 12)
Figure 8. Typical Current vs. Fre-
quency (Hot Temp) (pg. 12)
Table 5. DC Characteristics (pg. 15)
NOTES:
Page numbers refer to 80960SA data sheet number 272206-001.
REVISION HISTORY
Section
Section
-004
-004
-004
Last
Rev.
Last
Rev.
-001
-001
-001
-001
Deleted corresponding graph of open drain voltage vs. out-
put current.
Regraphed new data in three graphs instead of two.
Input Leakage Current (I
rately describe leakage of INT0 and LOCK as inputs.
I
Power Supply Current:
10 MHz
16 MHz
CC
max reduced:
Removed two LOCK pin Connection Recommendation
figures and added Figure 5 to reflect the new LOCK pin
connection recommendation of a single 910
resistor.
Obsolete figure (Test Load Circuit for Open-Drain
Output Pins) removed to reflect current test conditions.
I
WAS:
LOCK pin I
LOCK pin I
80960SA 16 MHz QFP added to product list.
New section added.
OL
value at 0.45V improved.
WAS:
OL
OL
2.5 mA
12 mA
value at 0.45V relaxed.
value at 0.60V deleted.
Description
LI2
Description
) Specification added to accu-
Was:
280
350
IS:
IS:
4.0 mA
6 mA
240
300
Is:
pullup