XC5VSX50T-1FFG665C Xilinx Inc, XC5VSX50T-1FFG665C Datasheet - Page 364

• Manufacturer Part Number: XC5VSX50T-1FFG665C
• Description: IC FPGA VIRTEX-5 50K 665-FCBGA
• Manufacturer: Xilinx Inc
• Series: Virtex™-5 SXTr

Specifications of XC5VSX50T-1FFG665C

• Total Ram Bits: 4866048
• Number Of Logic Elements/cells: 52224
• Number Of Labs/clbs: 4080
• Number Of I /o: 360
• Voltage - Supply: 0.95 V ~ 1.05 V
• Mounting Type: Surface Mount
• Operating Temperature: 0°C ~ 85°C
• Package / Case: 665-BBGA, FCBGA
• No. Of Logic Blocks: 8160
• No. Of Gates: 50000
• Family Type: Virtex-5 SXT
• No. Of Speed Grades: 1
• No. Of I/o's: 360
• Clock Management: PLL
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• For Use With: HW-V5-ML506-UNI-G - EVALUATION PLATFORM VIRTEX-5
• Number Of Gates: -
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant, Lead free / RoHS Compliant
• Other names: 122-1568

Chapter 8: Advanced SelectIO Logic Resources
364
Timing Characteristics
Reset Input Timing
Figure 8-8
timing parameter names change for different modes (SDR/DDR). However, the names do
not change when a different bus input width, including when two ISERDES are cascaded
together to form 10 bits. In DDR mode, the data input (D) switches at every CLK edge
(rising and falling).
X-Ref Target - Figure 8-8
Clock Event 1
•
Clock Event 2
•
Clock Event 1
As shown in
the pulse must take two different routes to get to ISERDES0 and ISERDES1, there are
different propagation delays for both paths. The difference in propagation delay is
emphasized. The path to ISERDES0 is very long and the path to ISERDES1 is very short,
such that each ISERDES receives the reset pulse in a different CLK cycle. The internal resets
for both CLK and CLKDIV are reset asynchronously when the RST input is asserted.
At time T
and the ISERDES can sample data.
At time T
sampled at the next positive clock edge.
CLK
CE
D
illustrates an ISERDES timing diagram for the input data to the ISERDES. The
Figure
ISCCK_CE
ISDCK_D
1
Figure 8-8: ISERDES Input Data Timing Diagram
T
8-9, the reset pulse is generated on the rising edge of CLKDIV. Because
ISCCK_CE
, before Clock Event 2, the input data pin (D) becomes valid and is
, before Clock Event 1, the clock enable signal becomes valid-High
www.xilinx.com
2
T
ISDCK_D
Virtex-5 FPGA User Guide
UG190 (v5.3) May 17, 2010
ug190_8_08_100307