TX14D12VM1CAA HITACHI, TX14D12VM1CAA Datasheet - Page 27

• Manufacturer Part Number: TX14D12VM1CAA
• Manufacturer: HITACHI

Specifications of TX14D12VM1CAA

• Lead Free Status / Rohs Status: Compliant

KAOHSIUNG HITACHI
ELECTRONICS CO.,LTD.
11.4 OPERATION PRECAUTION
(10) Top sheets shall be cleaned gently using a soft cloth such as those used for
(3) Lightly wipe to clean the dirty surface with absorbent cotton or other soft material
(4) Immediately wipe off saliva or water drop attached on the display area because
(5) Fogy dew deposited on the surface may cause a damage, stain or dirt to the
(6) Touching the display area or I/F pins with bare hands or contaminating them are
(7) In general, the glass is fragile so that, especially on its periphery, tends to be
(8) Maximum pressure to the surface must be less than 1.96×10
(9) Since the metal width is narrow on these locations (see page 9-1/1), please careful
(1) Using a LCM module beyond its maximum ratings may result in its permanent
(2) Response time will be extremely delayed at lower temperature than the specified
shown in chapter 4. Exceeding any of these conditions may adversely affect
its reliability.
like chamois, soaked in the recommended chemicals without scrubbing it hardly.
Always wipe the surface horizontally or vertically. Never give a wipe in a circle.
To prevent the display surface from damage and keep the appearance in good
state, it is sufficient, in general, to wipe it with absorbent cotton.
it may cause deformation or faded color.
polarizer.
When you need to take out the LCD module from some place at low temperature
for test, etc.
It is required to be warmed them up to temperature higher than room temperature
before taking them out.
prohibited, because the stain on the display area and poor insulation between
terminals are often caused by being touched with bare hands.
(Some cosmetics are detrimental to polarizer’s.)
cracked or chipped in handling. Please not give the LCD module sharp shocks
by falling, etc.
And if the pressure area is less than 1cm
1.96N.
with handling.
destruction.
LCM module’s should usually be used under recommended operating conditions
operating temperature range and on the other hand LCD’s shows dark blue at
higher temperature.
However those phenomena do not main defects of the LCD module. Those
phenomena will disappear in the specified operating temperature range.
glasses.
Hard wiping accumulated dust will leave scars on the surface even using a cloth.
DATE Nov.12,’10
No.
Sh.
7B64PS 2711-TX14D12VM1CAA-5
2
, maximum pressure must be less than
4
Pa.
PAGE 11-2/3