6-1445297-3 TE Connectivity, 6-1445297-3 Datasheet - Page 5

• Manufacturer Part Number: 6-1445297-3
• Description: REC.R/A SMT,30 POS,LF
• Manufacturer: TE Connectivity

Specifications of 6-1445297-3

• Product Type: Connector
• Connector Type: Connector Assembly
• Pcb Mounting Orientation: Right Angle
• Pcb Mount Style: Surface Mount
• Pcb Mount Retention: With
• Dielectric Withstanding Voltage (v): 250
• Insulation Resistance (m?): 500
• Voltage (vac): 30
• Current Rating (a): 1, 0.75
• Solder Tail Contact Plating: Tin over Nickel
• Number Of Positions: 30
• Pcb Mount Retention Type: Boardlock(s)
• Centerline (mm [in]): 0.80 [0.031]
• Contact Type: Socket
• Contact Base Material: Copper Alloy
• Contact Plating, Mating Area, Material: Gold (30)
• Connector Style: Receptacle
• Housing Material: Thermoplastic - GF
• Housing Color: Beige
• Ul Flammability Rating: UL 94V-0
• Rohs/elv Compliance: RoHS compliant, ELV compliant
• Lead Free Solder Processes: Reflow solder capable to 245°C, Reflow solder capable to 260°C
• Rohs/elv Compliance History: Always was RoHS compliant
• Approved Standards: UL E28476
• Applies To: Printed Circuit Board
• Temperature Range (°c): -55 – +85

4.
4.1.
4.2.
4.3.
4.4.
Rev B
QUALITY ASSURANCE PROVISIONS
Qualification Testing
A.
B.
Requalification Testing
If changes significantly affecting form, fit or function are made to the product or manufacturing process,
product assurance shall coordinate requalification testing, consisting of all or part of the original testing
sequence as determined by development/product, quality and reliability engineering.
Acceptance
Acceptance is based on verification that the product meets the requirements of Figure 1. Failures
attributed to equipment, test setup or operator deficiencies shall not disqualify the product. If product
failure occurs, corrective action shall be taken and specimens resubmitted for qualification. Testing to
confirm corrective action is required before resubmittal.
Quality Conformance Inspection
The applicable quality inspection plan shall specify the sampling acceptable quality level to be used.
Dimensional and functional requirements shall be in accordance with the applicable product drawing
and this specification.
Specimen Selection
Specimens shall be prepared in accordance with applicable Instruction Sheets and shall be
selected at random from current production. Each test group shall consist of 5 specimens.
Test Sequence
Qualification inspection shall be verified by testing specimens as specified in Figure 2.
108-1955
5 of 7