4-647010-5 TE Connectivity, 4-647010-5 Datasheet - Page 6

• Manufacturer Part Number: 4-647010-5
• Description: 15P MTA100 PSTD CONN ASSY LF
• Manufacturer: TE Connectivity

Specifications of 4-647010-5

• Connector Type: Connector Assembly
• Connector Design: Closed End
• Product Line: MTA-100
• Termination Method To Wire/cable: IDC Standard
• Wire Size (mm² [awg]): 0.12-0.15² [26]
• Mating Connector Lock: Without
• Four Points Of Contact: Without
• Shrouded: No
• Mounting Ears: Without
• Panel Mount Retention: Without
• Voltage Rating (vac): 250
• Solder Tail Contact Plating: Bright Tin
• Number Of Positions: 5
• Centerline (mm [in]): 2.54 [0.100]
• Narrow: No
• Post Number(s) Omitted: None
• Contact Type: Socket
• Contact Plating, Mating Area, Material: Gold (30) or (30) Total Gold Flash over Palladium Nickel
• Contact Base Material: Copper Alloy
• Connector Style: Receptacle
• Housing Color: Blue
• Mating Alignment: Without
• Ul Flammability Rating: UL 94V-2
• Housing Material: Nylon
• Rohs/elv Compliance: RoHS compliant, ELV compliant
• Lead Free Solder Processes: Not relevant for lead free process
• Rohs/elv Compliance History: Always was RoHS compliant
• Applies To: Wire/Cable
• Application Use: Wire-to-Wire

4.
4.1.
4.2.
4.3.
4.4.
Rev D
QUALITY ASSURANCE PROVISIONS
Qualification Testing
A.
B.
Requalification Testing
If changes significantly affecting form, fit or function are made to the product or manufacturing process,
product assurance shall coordinate requalification testing, consisting of all or part of the original testing
sequence as determined by development/product, quality and reliability engineering.
Acceptance
Acceptance is based on verification that the product meets the requirements of Figure 1. Failures
attributed to equipment, test setup or operator deficiencies shall not disqualify the product. When
product failure occurs, corrective action shall be taken and samples resubmitted for qualification.
Testing to confirm corrective action is required before resubmittal.
Quality Conformance Inspection
The applicable quality inspection plan will specify the sampling acceptable quality level to be used.
Dimensional and functional requirements shall be in accordance with the applicable product drawing
and this specification.
Sample Selection
Samples shall be prepared in accordance with applicable Instruction Sheets and shall be selected
at random from current production. All test groups shall each consist of mated pairs of MTA-100
posted connectors and standard connectors to form a wire-to-wire connector system unless
otherwise required by the test procedure. All test groups will also utilize strain relief dust covers
during testing to prevent wire removal from the IDC blade. Test group 1 shall consist of 5 mated,
16 position tin-lead plated samples terminated with 6 inch lengths of 22 AWG wire. Test group 2
shall consist of 3 mated, 16 position tin-lead plated samples terminated with 12 inch lengths of 22
AWG wire and 3, 16 position tin-lead plated samples terminated with 12 inch lengths of 28 AWG
wire. Test group 3 shall consist of 5 mated, 16 position gold plated samples terminated with 22
AWG wire. Test group 4 shall consist of 5 mated, 8 position tin-lead plated samples terminated
with 22 AWG wire. Test group 5 shall consist of 5 pieces each of 16 position tin-lead plated
samples in each wire gage.
Test Sequence
Qualification inspection shall be verified by testing samples as specified in Figure 2.
108-1050-1
6 of 11