AD73360LAR-REEL7 Analog Devices Inc, AD73360LAR-REEL7 Datasheet - Page 22

• Manufacturer Part Number: AD73360LAR-REEL7
• Description: IC ANALOG FRONT END 6CH 28-SOIC
• Manufacturer: Analog Devices Inc

Specifications of AD73360LAR-REEL7

• Number Of Channels: 6
• Rohs Status: RoHS non-compliant
• Number Of Bits: 16
• Power (watts): 80mW
• Voltage - Supply, Analog: 3V
• Voltage - Supply, Digital: 3V
• Package / Case: 28-SOIC (7.5mm Width)
• Analog Front End Type: General Purpose
• Analog Front End Category: General Purpose
• Interface Type: Serial (6-Wire)
• Sample Rate: 64KSPS
• Input Voltage Range: 0.789V
• Operating Supply Voltage (min): 2.7V
• Operating Supply Voltage (typ): 3.3V
• Operating Supply Voltage (max): 3.6V
• Resolution: 16b
• Number Of Adc's: 6
• Power Supply Type: Analog/Digital
• Operating Temp Range: -40C to 85C
• Operating Temperature Classification: Industrial
• Mounting: Surface Mount
• Pin Count: 28
• Package Type: SOIC W
• For Use With: EVAL-AD73360LEB - BOARD EVAL FOR AD73360L
• Lead Free Status / RoHS Status: Not Compliant

AD73360L
Figure 23 shows a comparison of SNR results achieved by vary-
ing either the Decimation Rate Setting or the DMCLK Rate
Settings.
Encoder Group Delay
The AD73360L implementation offers a very low level of group
delay, which is given by the following relationship:
where:
If final filtering is implemented in the DSP, the final filter’s
group delay must be taken into account when calculating overall
group delay.
DESIGN CONSIDERATIONS
Analog Inputs
The AD73360L features six signal conditioning inputs. Each
signal conditioning block allows the AD73360L to be used with
either a single-ended or differential signal. The applied signal
can also be inverted internally by the AD73360L if required.
The analog input signal to the AD73360L can be dc-coupled,
provided that the dc bias level of the input signal is the same as
the internal reference level (REFOUT). Figure 24 shows the
recommended differential input circuit for the AD73360L. The
circuit of Figure 24 implements first-order low-pass filters
with a 3 dB point at 34 kHz; these are the only filters that must
be implemented external to the AD73360L to prevent aliasing
of the sampled signal. Since the ADC uses a highly oversampled
approach that transfers the bulk of the antialiasing filtering into
the digital domain, the off-chip antialiasing filter need only be of
a low order. It is recommended that for optimum performance the
capacitors used for the antialiasing filter be of high-quality
dielectric (NPO).
Order is the order of the decimator (= 3),
M is the decimation factor (= 32), and
Tdec is the decimation sample interval (= 1/2.048e6).
=> Group Delay (Decimator) = 3 × (32 – 1)/2 × (1/2.048e6)
= 22.7 µs
Group Delay (Decimator) = Order × ((M – 1)/2) × Tdec
81
80
79
78
77
76
75
74
73
72
71
8
16
SAMPLING FREQUENCY – kHz
24
32
DMCLK = MCLK
40
REDUCED
DMCLK
48
56
64
The AD73360L’s on-chip 38 dB preamplifier can be enabled
when there is not enough gain in the input circuit; the preampli-
fier is configured by bits IGS0–2 of CRD. The total gain must be
configured to ensure that a full-scale input signal produces a
signal level at the input to the sigma-delta modulator of the
ADC that does not exceed the maximum input range.
The dc biasing of the analog input signal is accomplished with
an on-chip voltage reference. If the input signal is not biased at
the internal reference level (via REFOUT), then it must be
ac-coupled with external coupling capacitors. CIN should be
0.1 µF or larger. The dc biasing of the input can then be accom-
plished using resistors to REFOUT as in Figure 25.
Figures 26 and 27 detail ac- and dc-coupled input circuits for
single-ended operation respectively.
VIN
VIN
VIN
VIN
TO INPUT BIAS
TO INPUT BIAS
CIRCUITRY
CIRCUITRY
CIN
CIN
CIN
100
0.047 F
0.047 F
0.047 F
100
100
0.047 F
100
100
100
0.1 F
0.1 F
0.1 F
10k
0.1 F
10k
REFOUT
REFOUT
0.047 F
REFOUT
0.047 F
10k
REFOUT
REFCAP
VINPx
VINNx
REFCAP
VINNx
VINPx
VINPx
VINNx
REFCAP
VINPx
VINNx
REFCAP
REFERENCE
REFERENCE
REFERENCE
REFERENCE
VOLTAGE
VOLTAGE
VOLTAGE
VOLTAGE