DS2415P+ Maxim Integrated Products, DS2415P+ Datasheet - Page 7

• Manufacturer Part Number: DS2415P+
• Description: IC TIME CHIP 1-WIRE 6-TSOC
• Manufacturer: Maxim Integrated Products
• Type: Time Chipr

Specifications of DS2415P+

• Time Format: Binary
• Date Format: Binary
• Interface: 1-Wire Serial
• Voltage - Supply: 2.5 V ~ 5.5 V
• Operating Temperature: -40°C ~ 85°C
• Mounting Type: Surface Mount
• Package / Case: 6-TSOC
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Memory Size: -

DS2415
HARDWARE CONFIGURATION Figure 6
1-WIRE BUS SYSTEM
The 1-Wire bus is a system that has a single bus master and one or more slaves. In all instances the
DS2415 behaves as a slave. The discussion of this bus system is broken down into three topics: hardware
configuration, transaction sequence, and 1-Wire signaling (signal types and timing). A 1-Wire protocol
defines bus transactions in terms of the bus state during specified time slots that are initiated on the falling
edge of sync pulses from the bus master. For a more detailed protocol description, refer to Chapter 4 of
the Book of DS19xx iButton Standards.
Hardware Configuration
The 1-Wire bus has only a single line by definition; it is important that each device on the bus be able to
drive it at the appropriate time. To facilitate this, each device attached to the 1-Wire bus must have open
drain or 3-state outputs. The 1-Wire input of the DS2415 is open drain with an internal circuit equivalent
to that shown in Figure 6. A multidrop bus consists of a 1-Wire bus with multiple slaves attached. The 1-
Wire bus has a maximum data rate of 16.3kbits per second and requires a pullup resistor of approximately
5kW.
The idle state for the 1-Wire bus is high. If for any reason a transaction needs to be suspended, the bus
must be left in the idle state if the transaction is to resume. If this does not occur and the bus is left low
for more than 120ms, one or more of the devices on the bus may be reset. Since the DS2415 gets all its
energy for operation through its V
pin it will not perform a power-on reset if the 1-Wire bus is low for
BAT
an extended time period.
Transaction Sequence
The protocol for accessing the DS2415 via the 1-Wire port is as follows:
§ Initialization
§ ROM Function Command
§ Clock Function Command
7 of 14