HB28K032MM3 Renesas Electronics America, HB28K032MM3 Datasheet - Page 59

• Manufacturer Part Number: HB28K032MM3
• Manufacturer: Renesas Electronics America
• Type: MultiMedia Cardr

Specifications of HB28K032MM3

• Density: 32MByte
• Operating Supply Voltage (typ): 3.3V
• Operating Temperature (min): -25C
• Operating Temperature (max): 85C
• Package Type: Not Required
• Mounting: Surface Mount
• Pin Count: 7
• Operating Temperature Classification: Commercial
• Operating Supply Voltage (min): 2.7V
• Operating Supply Voltage (max): 3.6V
• Programmable: Yes
• Lead Free Status / RoHS Status: Compliant

HB28K032/L064/J128/J256/J512MM3, HB28K032/L064/J128/J256RM3
Erase and Write Protect Management
The erase and write protect management procedures in the SPI mode are identical to those of the
MultiMediaCard mode. While the card is erasing or changing the write protection bits of the predefined
sector list, it will be in a busy state and hold the DataOut line low. Figure “No Data Operations” illustrates
a ‘no data’ bus transaction with and without busy signaling.
Reading CID/CSD Registers
Unlike the MultiMediaCard protocol (where the register contents are sent as a command response), reading
the contents of the CSD and CID registers in SPI mode is a simple read-block transaction. The card will
respond with a standard response token (refer to Figure “Read Operation”) followed by a data block of 16
bytes suffixed with a 16-bit CRC. The data timeout for the CSD command cannot be set to the card TAAC
since this value is stored in the CSD. Therefore the standard response timeout value (N
latency of the CSD register.
Reset Sequence
The MultiMediaCard requires a defined reset sequence. After power on reset or CMD0 (software reset) the
card enters an idle state. At this state the only legal host command is CMD1 (SEND_OP_COND) and
CMD58 (READ_OCR). In SPI mode, as opposed to MultiMediaCard mode, CMD1 has no operands and
does not return the contents of the OCR register. Instead, the host may use CMD58 (available in SPI mode
only) to read the OCR register. Furthermore, it is in the responsibility of the host to refrain from accessing
cards that do not support its voltage range. The usage of CMD58 is not restricted to the initializing phase
only, but can be issued at any time. The host must poll the card (by repeatedly sending CMD1) until the
‘in-idle-state’ bit in the card response indicates (by being set to 0) that the card completed its initialization
processes and is ready for the next command. The host must poll the card (by repeatedly sending CMD1)
until the ‘in-idle-state’ bit in the card response indicates (by being set to 0) that the card completed its
initialization processes and is ready for the next command.
Rev.0.02, Sep.15.2004, page 59 of 89
Data in
Data out
to card
from
host
command
response
‘No Data’ Operations
to host
from
card
to card
from
host
command
response busy
CR
to host
) is used for read
from
card