LAN9215-MT Standard Microsystems (SMSC), LAN9215-MT Datasheet - Page 90
![](/photos/31/30/313088/100pin_tqfp_sml.jpg)
LAN9215-MT
Manufacturer Part Number
LAN9215-MT
Description
Manufacturer
Standard Microsystems (SMSC)
Datasheet
1.LAN9215-MT.pdf
(143 pages)
Specifications of LAN9215-MT
Operating Supply Voltage (typ)
3.3V
Operating Supply Voltage (min)
2.97V
Operating Supply Voltage (max)
3.63V
Operating Temperature Classification
Commercial
Mounting
Surface Mount
Pin Count
100
Lead Free Status / RoHS Status
Compliant
Available stocks
Company
Part Number
Manufacturer
Quantity
Price
Company:
Part Number:
LAN9215-MT
Manufacturer:
BROADCOM
Quantity:
450
Company:
Part Number:
LAN9215-MT
Manufacturer:
Standard
Quantity:
1 643
Company:
Part Number:
LAN9215-MT
Manufacturer:
SMSC
Quantity:
9
Part Number:
LAN9215-MT
Manufacturer:
SMSC
Quantity:
20 000
Revision 2.7 (03-15-10)
BITS
5-4
3
2
1
0
WAKE-UP Status (WUPS) – This field indicates the cause of a wake-up
event detection as follows
00b -- No wake-up event detected
01b -- Energy detected
10b -- Wake-up frame or magic packet detected
11b -- Indicates multiple events occurred
WUPS bits are cleared by writing a ‘1’ to the appropriate bit. The device must
return to the D0 state (READY bit set) before these bits can be cleared.
Note:
PME indication (PME_IND). The PME signal can be configured as a pulsed
output or a static signal, which is asserted upon detection of a wake-up
event.
When set, the PME signal will pulse active for 50mS upon detection of a
wake-up event.
When clear, the PME signal is driven continuously upon detection of a wake-
up event.
The PME signal can be deactivated by clearing the WUPS bits, or by
clearing the appropriate enable (refer to
Management Event Indicators," on page
PME Polarity (PME_POL). This bit controls the polarity of the PME signal.
When set, the PME output is an active high signal. When reset, it is active
low. When PME is configured as an open-drain output this field is ignored,
and the output is always active low.
PME Enable (PME_EN). When set, this bit enables the external PME signal.
This bit does not affect the PME interrupt (PME_INT).
Device Ready (READY). When set, this bit indicates that LAN9215 is ready
to be accessed. This register can be read when LAN9215 is in any power
management mode. Upon waking from any power management mode,
including power-up, the host processor can interrogate this field as an
indication when LAN9215 has stabilized and is fully alive. Reads and writes
of any other address are invalid until this bit is set.
Note:
In order to clear this bit, it is required that all event sources be
cleared as well. The event sources are described in
PME and PME_INT Signal Generationon page
With the exception of HW_CFG and PMT_CTRL, read access to
any internal resources is forbidden while the READY bit is cleared.
DESCRIPTION
DATASHEET
Section 3.9.2.3, "Power
43).
90
43.
16-bit Non-PCI 10/100 Ethernet Controller with HP Auto-MDIX Support
Figure 3.10
NASR
R/WC
TYPE
R/W
R/W
R/W
RO
SMSC LAN9215
DEFAULT
Datasheet
00
0b
0b
0b
-