TLE62512GXT Infineon Technologies, TLE62512GXT Datasheet - Page 12

• Manufacturer Part Number: TLE62512GXT
• Manufacturer: Infineon Technologies

Specifications of TLE62512GXT

• Number Of Transceivers: 1
• Power Down Mode: Sleep/Standby
• Operating Supply Voltage (max): 5.25V
• Operating Supply Voltage (typ): 5V
• Operating Supply Voltage (min): 4.75V
• Package Type: DSO
• Operating Temperature (max): 150C
• Operating Temperature (min): -40C
• Operating Temperature Classification: Automotive
• Mounting: Surface Mount
• Pin Count: 14
• Lead Free Status / RoHS Status: Compliant

5.4
The Go - To - Sleep command is a transition mode allowing external circuitry like a microcontroller to prepare the
ECU for the Sleep mode. The TLE6251-2G stays in the Go - To - Sleep command for the maximum time t =
after exceeding the time
possible via the Go - To - Sleep command. During the Go-To Sleep command the following functions on the
TLE6251-2G are available:
•
•
•
•
•
•
•
•
•
Setting the NSTB pin to logical “Low”, while the EN signal remains at logical “High”, activates the Go - To - Sleep
command. The Go -To - Sleep command can be entered from Normal Operation Mode, Receive - Only Mode and
from Stand - By Mode.
5.5
The Sleep Mode is a power save mode. In Sleep Mode the current consumption of the TLE6251-2G is reduced to
a minimum while the device is still able to Wake - Up by a message on the CAN bus or a local Wake - Up event
on the pin WK. Most of the functions of the TLE6251-2G are disabled:
•
•
•
•
•
•
•
•
•
There are only two ways to enter Sleep Mode:
•
•
Data Sheet
The output driver stage is disabled.
The normal receiver unit is disabled.
The low power receiver is active and monitors the CAN bus. In case of a message on the CAN bus the
TLE6251-2G sets an internal Wake - Up flag.
The local Wake - Up pin is active and can detect a local Wake - Up event.
The INH output is active and set to
Through the internal resistors
The TxD pin is disabled.
The failure diagnostic is disabled.
The under - voltage detection on all 3 power supplies
The output driver stage is disabled.
The normal receiver unit is disabled.
The low power receiver is active and monitors the CAN bus. In case of a message on the CAN bus the
TLE6251-2G changes from Sleep Mode to Stand - By Mode and sets an internal Wake - Up flag.
The local Wake - Up pin is active and in case of a signal change on the WK pin the operation mode changes to
Stand - By Mode.
The INH output is floating.
Through the internal resistors
If the power supplies
The TxD pin is disabled
The under - voltage detection on the power supplies
in case of an under - voltage event.
The device can activate the Sleep Mode via the mode control pins EN and NSTB.
An under - voltage event on the power supplies
Go - To - Sleep Command
Sleep Mode
V
t
h(min)
CC
and
the device changes into Sleep Mode. A mode change into Sleep Mode is only
R
R
V
I
I
IO
(see
(see
are present, the RxD pin indicates the Wake - Up event.
V
S
Figure
Figure
.
1), the pins CANH and CANL are connected to GND.
1), the pins CANH and CANL are connected to GND.
V
CC
12
and
V
V
S
CC
is active and sends the device into Stand - By Mode
V
,
IO
V
IO
changes the operation mode to Sleep Mode.
and
V
S
is active.
Rev. 1.0, 2009-05-07
Operation Modes
TLE6251-2G
t
h(min)
,