MT48LC4M32LFF5-8 IT:G Micron Technology Inc, MT48LC4M32LFF5-8 IT:G Datasheet - Page 32

• Manufacturer Part Number: MT48LC4M32LFF5-8 IT:G
• Description: DRAM Chip Mobile SDRAM 128M-Bit 4Mx32 3.3V 90-Pin VFBGA Tray
• Manufacturer: Micron Technology Inc
• Type: Mobile SDRAMr

Specifications of MT48LC4M32LFF5-8 IT:G

• Density: 128 Mb
• Maximum Clock Rate: 125 MHz
• Package: 90VFBGA
• Address Bus Width: 14 Bit
• Operating Supply Voltage: 3.3 V
• Maximum Random Access Time: 19|8|7 ns
• Operating Temperature: -40 to 85 °C
• Format - Memory: RAM
• Memory Type: Mobile SDRAM
• Memory Size: 128M (4Mx32)
• Speed: 125MHz
• Interface: Parallel
• Voltage - Supply: 3 V ~ 3.6 V
• Package / Case: 90-VFBGA
• Organization: 4Mx32
• Address Bus: 14b
• Access Time (max): 19/8/7ns
• Operating Supply Voltage (typ): 3.3V
• Package Type: VFBGA
• Operating Temp Range: -40C to 85C
• Operating Supply Voltage (max): 3.6V
• Operating Supply Voltage (min): 3V
• Supply Current: 115mA
• Pin Count: 90
• Mounting: Surface Mount
• Operating Temperature Classification: Industrial
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

PDF: 09005aef807f4885/Source: 09005aef8071a76b
128Mbx16x32Mobile_2.fm - Rev. M 1/09 EN
A fixed-length READ burst may be followed by, or truncated with, a PRECHARGE
command to the same bank (provided that auto precharge was not activated), and a full-
page burst may be truncated with a PRECHARGE command to the same bank. The
PRECHARGE command should be issued x cycles before the clock edge at which the last
desired data element is valid, where x = CL - 1. This is shown in Figure 18 on page 33 for
each possible CL; data element n + 3 is either the last of a burst of four or the last desired
of a longer burst. Following the PRECHARGE command, a subsequent command to the
same bank cannot be issued until
hidden during the access of the last data element(s).
In the case of a fixed-length burst being executed to completion, a PRECHARGE
command issued at the optimum time (as described above) provides the same operation
that would result from the same fixed-length burst with auto precharge. The disadvan-
tage of the PRECHARGE command is that it requires that the command and address
buses be available at the appropriate time to issue the command; the advantage of the
PRECHARGE command is that it can be used to truncate fixed-length or full-page bursts.
32
t
RP is met. Note that part of the row precharge time is
Micron Technology, Inc., reserves the right to change products or specifications without notice.
128Mb: x16, x32 Mobile SDRAM
©2001 Micron Technology, Inc. All rights reserved.
READs