BSP149 E6327 Infineon Technologies, BSP149 E6327 Datasheet - Page 9

• Manufacturer Part Number: BSP149 E6327
• Description: MOSFET N-CH 200V 660MA SOT-223
• Manufacturer: Infineon Technologies
• Series: SIPMOS®r

Specifications of BSP149 E6327

• Fet Type: MOSFET N-Channel, Metal Oxide
• Fet Feature: Depletion Mode
• Rds On (max) @ Id, Vgs: 1.8 Ohm @ 660mA, 10v
• Drain To Source Voltage (vdss): 200V
• Current - Continuous Drain (id) @ 25° C: 660mA
• Vgs(th) (max) @ Id: 1V @ 400µA
• Gate Charge (qg) @ Vgs: 14nC @ 5V
• Input Capacitance (ciss) @ Vds: 430pF @ 25V
• Power - Max: 1.8W
• Mounting Type: Surface Mount
• Package / Case: SOT-223 (3 leads + Tab), SC-73, TO-261
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Other names: BSP149E6327T; SP000011104

Rev. 1.2
Published by
Infineon Technologies AG
Bereich Kommunikation
St.-Martin-Straße 53
D-81541 München
© Infineon Technologies AG 1999
All Rights Reserved.
Attention please!
The information herein is given to describe certain components and shall not be considered as
warranted characteristics.
Terms of delivery and rights to technical change reserved.
We hereby disclaim any and all warranties, including but not limited to warranties of non-infringement,
regarding circuits, descriptions and charts stated herein.
Infineon Technologies is an approved CECC manufacturer.
Information
For further information on technology, delivery terms and conditions and prices, please contact your
nearest Infineon Technologies office in Germany or our Infineon Technologies representatives worldwide
(see address list).
Warnings
Due to technical requirements, components may contain dangerous substances.
For information on the types in question, please contact your nearest Infineon Technologies office.
Infineon Technologies' components may only be used in life-support devices or systems with the
expressed written approval of Infineon Technologies if a failure of such components can reasonably
be expected to cause the failure of that life-support device or system, or to affect the safety or
effectiveness of that device or system. Life support devices or systems are intended to be implanted
in the human body, or to support and/or maintain and sustain and/or protect human life. If they fail,
it is reasonable to assume that the health of the user or other persons may be endangered.
page 9
BSP149
2005-11-28