1980-1005 BLUE CHIP TECHNOLOGY, 1980-1005 Datasheet - Page 2

• Manufacturer Part Number: 1980-1005
• Description: CARD, DATA ACQUISITION, PCI-ADC
• Manufacturer: BLUE CHIP TECHNOLOGY

Specifications of 1980-1005

• Interface Type: PCI
• External Length / Height: 165mm
• External Width: 100mm
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

Analogue Inputs
Number:
Range:
Resolution:
Gain settings:
Gain accuracy:
Input offset accuracy:
Max sample rate:
Input settling time:
Data buffer:
Analogue Outputs
Number of outputs:
Output resolution:
Format:
Output levels:
Drive capability:
Accuracy:
Interrupts
Interrupt Sources:
Levels Supported:
Address Overhead:
16 single ended inputs or 8 differential input
± 5 Volts maximum operating
12 bits
1, 10, 100 or 1000, software selectable.
All gains without auto-cal. = ± 0.3 % . All gains with
auto-cal. = ± 0.05 %
Gain = 1 or 10 without auto-cal. = ± 0.1 %
Gain = 1 or 10 with auto-cal. = ± 0.05 %
Gain = 100 without auto-cal. = ± 0.2 %
Gain = 100 with auto-cal. = ± 0.05 %
Gain = 1000 without auto-cal. = ± 1.2 %
Gain = 1000 with auto-cal. = ± 0.05 %
FIFO 16 bits wide x 1024 samples, with channel
number identification on each sample
4
12 bits
Constant voltage or constant current
Individually software selectable.
Voltage mode = ± 10 volts
Current mode = ± 20 mA
Voltage mode = ± 20 mA (FS into 500R min.)
Current mode = ± 12 volts (FS into 600R max.)
Voltage mode = ± 0.15 %
Current mode = ± 3.5 %
Register selectable to 3 Counter/timer outputs,
2 PIO handshake control lines,
ADC busy and FIFO Not Empty/Half full.
All PCI interrupts
26 I/O addresses in 3 PCI address spaces
Technical Specification
Digital Input/Output
Number of I/O
Channels:
Signal Levels:
Outputs:
Drive Current:
Input Loading:
Termination resistors:
Counter/Timers
Counter/timers:
On board Oscillator:
Power
Board Power
Requirement:
Physical
Signal Connections:
Dimensions:
24 arranged as 3 x 8 I/O bits
5 Volt TTL Logic Levels
Logic Low Level: 0 V (min.) - 0.4 V (max.) @ IOL =
2.5 mA
Logic High Level: 3.5 V (min.) - 5 V (max.) @ IOH =
-400 mA
2.5 mA (Logic Low) Vout = 0.4 Volts
-400 mA (Logic High) Vout = 3.5 Volts
±10 mA
Resistor packs are fitted to each I/O port to pull the
lines to + 5 volts. Optionally they may pull the lines
down to 0 volts.
3 x 16 Bit. Counter/timers may be cascaded.
Frequency 4 MHz.
Stability ± 100ppm 0 - 70°C
+3.3 Volts, 0.5 W maximum
+5 Volts, 1.2 W maximum
1 x 50 way male ‘D-type’ plug
165 (L) x 100 (H) board only
180 (L) x 122 (H) x 22 (W) including bracket
Certificate No FM 33069
BS EN ISO 9001:2000