DP-DSG2 METCAL, DP-DSG2 Datasheet - Page 17

• Manufacturer Part Number: DP-DSG2
• Description: Desoldering Tool Assembly
• Manufacturer: METCAL

Specifications of DP-DSG2

• Accessory Type: Desolder Tool Assembly
• Peak Reflow Compatible (260 C): No
• Leaded Process Compatible: No
• For Use With: OK Internationals Metcal SP440-21 Desoldering Station
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

The ultimate in versatility
Choose the correct geometry
Metcal TATC tip cartridges are available in the following tip
geometries and in two standard temperature ranges (500 Series
and 600 Series).
Metcal’s unique design means that a wide range of compo-
nents can be removed by a small range of tips. You can remove
28-pin SOIC’s, tantalums, and 0603 chip caps without changing
tips. Where it is possible, a beveled edge is provided to improve
versatility. When you use this feature, make sure that all leads
are contacted during removal. See illustration below.
Choose the proper Series
Each Metcal cartridge is designed to deliver high power in
response to loads. For this reason, you can often work with a
Metcal cartridge at a temperature lower than with a conventional
iron. 500 Series cartridges will work well for most applications.
TATC tip cartridges for MX Talon
Tip cartridges can be inserted three ways
Measurement “A” (Span) refers to the minimum and maximum
distance between two cartridges when used together in the
Talon
Part Number
TATC-x01
TATC-x02
TATC-x03
TATC-x04
TATC-x05
TATC-x06
x=5 for 500 Series, 6 for 600 Series
*Denotes a corner bevel for small components.
Please note
TATC tip cartridges are for use with the Talon only
A
®
in the three possible configurations.
D i m e n s i o n s
Description
Fine Point Tips
Blades,
Blades,
Blades,
TSOP
Blades,
32*
0.25*
0.62*
0.81*
1.10*
®
systems
i n
Span (A)
0.03–0.37
0.00–0.36
0.06–0.42
0.10–0.47
0.00–0.78
0.00–0.66
i n c h e s
15