R88A-CRWB010NE Omron, R88A-CRWB010NE Datasheet - Page 174

no-image

R88A-CRWB010NE

Manufacturer Part Number
R88A-CRWB010NE
Description
Encoder Cable For Servo Motor
Manufacturer
Omron
Datasheet

Specifications of R88A-CRWB010NE

Lead Free Status / Rohs Status
Lead free / RoHS Compliant
3-18
System Design and Installation
2.Strip the covering off the ends of the wires.
3.Open the wire insertion slots in the Terminal Block
4.Insert the wire into the slot.
5.Mount the Terminal Block to the Servo Driver.
Prepare wires of the right sizes, according to the tables provided under Terminal Block Wire Sizes
above, and strip off 8 or 9 mm of the covering from the end of each wire.
There are two ways to open the wire insertion slots, as follows:
With the slot held open, insert the end of the wire. Then let the slot close by releasing the pressure
from the lever or the screwdriver.
After all of the terminals have been wired, return the Terminal Block to its original position on the
Servo Driver.
• Pry the slot open using the lever that comes with the Servo Driver (as in Fig. A).
• Insert a flat-blade screwdriver (end width: 3.0 to 3.5 mm) into the opening for Servo Driver in-
stallation, and press down firmly to open the slot (as in Fig. B).
Fig. A
8 to 9 mm
231-131 Lever
(Wago Company
of Japan)
Fig. B
210-120J Driver
(Wago Company
of Japan)
Chapter 3

Related parts for R88A-CRWB010NE