NT631C-ST153B-EV3 Omron, NT631C-ST153B-EV3 Datasheet - Page 162

• Manufacturer Part Number: NT631C-ST153B-EV3
• Description: 10.48-ColrDisplay,TFT,Blk,Eng
• Manufacturer: Omron

Specifications of NT631C-ST153B-EV3

• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

6-5-2
Operations in the System Installer Mode
Clearing/Installing the System Program
Reference:
Use this function when the system program of the NT631/NT631C has been
corrupted, or when installing a new system program.
Clear/install the system program by following the menu operation from the
System Installer mode menu shown below.
• In order to install a system program, the system installer must also be
• When the system program is cleared by mistake, it becomes impossible
• It becomes possible to install the system program inside the Memory Unit
installed at the Support Tool. The system installer is an accessory with the
Support Tool (NT-ZJCAT1-EV4). When installing the Support Tool in a
personal computer, install the system installer also. For details on the
method for installing the system installer at the Support Tool side, and the
operating procedure, refer to the NT-series Support Tool Ver. 4.@ for Win-
dows Operation Manual (V061-E1-@).
to use the NT631/NT631C at all. Check that the system installer is
installed at the Support Tool side before deleting the program. However,
note that the registered screen data and memory switch settings are
retained.
automatically by installing the Memory Unit at startup (Refer to 3-5 Using
a Memory Unit).
Select English or Japanese.
The System Installer mode menu is
displayed.
If there is no system program or the
system program has been corrupted,
the message System Program not
exist or incorrect. is displayed at the
bottom of the screen.
From here on, this manual assumes that
English has been selected here.
Section 6-5
145