NT31C-ST143-EV3 Omron, NT31C-ST143-EV3 Datasheet - Page 188

• Manufacturer Part Number: NT31C-ST143-EV3
• Description: 5.7 8-Color Dsp,STN,Ivory,Eng
• Manufacturer: Omron

Specifications of NT31C-ST143-EV3

• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

6-9-2
6-9-3
System Settings
Setting the Start-up Wait Time
Setting the Key Press Sound
The Start-up Wait Time is the time lapse until the NT31/NT31C switches to
the RUN mode after its power has been switched ON or after it has been
reset. Set this item if it takes some time for the host to start operation. Nothing
is displayed during the Start-up Wait Time.
The setting range is 0 to 10 seconds. The default (factory) setting is 00sec.
Set the system start-up wait time by following the menu operation from the
System Menu shown below.
To set other memory switches, select the relevant screen using the [ ] (next
screen) or [ ] (previous screen) touch switch, then make the setting.
It is possible to set whether or not the key sound is sounded when a touch
switch on the NT31/NT31C screen is pressed.
• To confirm the settings and quit the memory switch setting screen, press
• To quit the memory switch setting screen without confirming the settings,
• ON: When a touch switch is pressed, the key sound sounds for 0.2 sec-
• OFF: The key sound does not sound when touch switches are pressed.
the Quit touch switch. The settings made last will be set and the NT31/
NT31C will return to the MAINTENANCE MODE MENU screen.
press the Abort touch switch. The NT31/NT31C will return to the MAIN-
TENANCE MODE MENU screen with the previous settings still in effect.
onds.
Ver 4.12
Select Maintenance Mode.
Select Memory Switch.
01 02 03 .... 09 10 00 01 ....
The setting option changes each time the
touch switch is pressed, according to the
following sequence.
Press Start-up Wait Time to display the
required time lapse.
Section 6-9
171