ZMOTIONL100ZCOG Zilog, ZMOTIONL100ZCOG Datasheet - Page 15

• Manufacturer Part Number: ZMOTIONL100ZCOG
• Description: EVALUATION KIT Z8FS040 ZMOTION
• Manufacturer: Zilog
• Series: ZMOTION™r

Specifications of ZMOTIONL100ZCOG

• Sensor Type: Motion, PIR (Pyroelectric Infrared)
• Sensing Range: 5m x 5m, 60 Degree Detection Pattern
• Interface: Serial
• Sensitivity: Adjustable
• Voltage - Supply: 5V
• Embedded: Yes
• Utilized Ic / Part: Z8FS040B
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 269-2511

PS028511-0112
Signal Mnemonic
Analog
ANA[7:0]
V
Oscillators
X
X
Clock Input
CLKIN
LED Drivers
LED
On-Chip Debugger
DBG
Reset
RESET
Power Supply
V
AV
V
AV
REF
IN
OUT
DD
SS
DD
SS
Caution:
I/O
I
I/O
I
O
I
O
I/O
I/O
I
I
I
I
Table 3. Z8FS040 MCU Signal Descriptions (Continued)
Description
converter (ADC).
Analog-to-digital converter reference voltage input, or buffered output for
internal reference.
External Crystal Input. This is the input pin to the crystal oscillator. A
crystal can be connected between it and the X
oscillator. In addition, this pin is used with external RC networks or
external clock drivers to provide the system clock.
External Crystal Output. This pin is the output of the crystal oscillator. A
crystal can be connected between it and the X
oscillator.
used as the system clock.
Direct LED drive capability. All port C pins have the capability to drive an
LED without any other external components. These pins have
programmable drive strengths set by the GPIO block.
the On-Chip Debugger.
The DBG pin is open-drain and requires a pull-up resistor to ensure
proper operation.
a reset indicator; the Z8 Encore! XP forces this pin low when in reset.
This pin is open-drain and features an enabled internal pull-up resistor.
Digital Power Supply.
Analog Power Supply.
Digital Ground.
Analog Ground.
Analog Port. These signals are used as inputs to the analog-to-digital
Clock Input Signal. This pin may be used to input a TTL-level signal to be
Debug. This signal is the control and data input and output to and from
RESET. Generates a Reset when asserted (driven Low). Also serves as
ZMOTION™ Detection and Control Family
OUT
IN
Product Specification
pin to form the
pin to form the
Signal Descriptions
8