OM13005,598 NXP Semiconductors, OM13005,598 Datasheet - Page 13

• Manufacturer Part Number: OM13005,598
• Description: BOARD EVAL EM773 METER US PLUG
• Manufacturer: NXP Semiconductors
• Type: Other Power Managementr

Specifications of OM13005,598

• Design Resources: Plug Meter Schematics, Gerber Files USB Dongle Schematics, Gerber Files
• Main Purpose: Power Management, Energy/Power Meter
• Embedded: Yes, MCU, 32-Bit
• Utilized Ic / Part: EM773FHN33,551
• Interface Type: USB
• Maximum Operating Temperature: + 150 C
• Operating Supply Voltage: 1.8 V to 3.6 V
• Product: Power Management Development Tools
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Primary Attributes: -
• Secondary Attributes: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• For Use With/related Products: EM773, OL2381
• Other names: 568-6680

NXP Semiconductors
EM773
Objective data sheet
7.14.1 Features
7.15.1 Crystal oscillators
7.13 System tick timer
7.14 Watchdog timer
7.15 Clocking and power control
The ARM Cortex-M0 includes a system tick timer (SYSTICK) that is intended to generate
a dedicated SYSTICK exception at a fixed time interval (typically 10 ms).
The purpose of the watchdog is to reset the microcontroller within a selectable time
period.
The EM773 includes three independent oscillators. These are the system oscillator, the
Internal RC oscillator (IRC), and the Watchdog oscillator. Each oscillator can be used for
more than one purpose as required in a particular application.
•
•
•
•
•
•
•
•
•
•
Four match registers per timer that allow:
– Continuous operation with optional interrupt generation on match.
– Stop timer on match with optional interrupt generation.
– Reset timer on match with optional interrupt generation.
Up to four external outputs corresponding to match registers, with the following
capabilities:
– Set LOW on match.
– Set HIGH on match.
– Toggle on match.
– Do nothing on match.
Internally resets chip if not periodically reloaded.
Debug mode.
Enabled by software but requires a hardware reset or a watchdog reset/interrupt to be
disabled.
Incorrect/Incomplete feed sequence causes reset/interrupt if enabled.
Flag to indicate watchdog reset.
Programmable 24-bit timer with internal prescaler.
Selectable time period from (T
multiples of T
The Watchdog Clock (WDCLK) source can be selected from the Internal RC oscillator
(IRC), the Watchdog oscillator, or the main clock. This gives a wide range of potential
timing choices of Watchdog operation under different power reduction conditions. It
also provides the ability to run the WDT from an entirely internal source that is not
dependent on an external crystal and its associated components and wiring for
increased reliability.
All information provided in this document is subject to legal disclaimers.
cy(WDCLK)
Rev. 1 — 1 September 2010
× 4.
cy(WDCLK)
× 256 × 4) to (T
cy(WDCLK)
Energy metering IC
× 2
© NXP B.V. 2010. All rights reserved.
24
× 4) in
EM773
13 of 45