CY3210-28XXX Cypress Semiconductor Corp, CY3210-28XXX Datasheet - Page 12

• Manufacturer Part Number: CY3210-28XXX
• Description: EVALUATION POD FOR CY8C28X PSOC
• Manufacturer: Cypress Semiconductor Corp
• Series: PSoC®r

Specifications of CY3210-28XXX

• Accessory Type: Emulation Pod
• Interface Type: ICE, I2C, RS232, MiniProg,
• Operating Supply Voltage: 9V, 12 V
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• For Use With/related Products: CY8C28 Family
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant, Lead free / RoHS Compliant

Quick Start
2.2.2
2.2.3
12
2. Place shunts on pin2 and 3 of JP3 (Default Setting).
3. Connect your computer to the CapSense test board ISSP Connector (J3) using the PSoC
4. Open PSoC Programmer by going to the Windows Start menu and selecting All Programs >
5. From the Port menu, select MiniProg1/<Identification Code>
6. Click Toggle Device Power. The D1 and D2 LEDs on the CY3280-28XXX board light red.
Testing the Board
Touch one or more buttons with your finger. The LEDs light up corresponding to the buttons being
pressed.
Figure 2-1. CapSense Buttons
Resetting the Board to the Original Factory Programming
Follow these steps to reset the board to the original factory installed programming:
1. Place shunts on pins 2 and 3 of JP1 and pins 1 and 2 of JP4. (Default Setting)
2. To reset the board to the factory conditions, connect your computer to the CY3280-28XXX board
3. Open PSoC Programmer by going to the Windows Start menu All Programs > Cypress > PSoC
4. Click File Load, navigate to, and open the CY3280_28XXX_slm.hex file on the CD at:
5. From the Device Family menu, select CY8C28XXX.
6. From the Device menu, select CY8C28645-24LTXI.
7. Click Program. "Programming Succeeded..." appears in the Actions pane when programming is
MiniProg and a USB cable. If this is your first time using the MiniProg, you will need to install the
driver using these steps before proceeding:
a. When the Found New Hardware Wizard opens, select Install the software automatically
b. A warning message may tell you that the software you are trying to install has not passed Win-
c. When the installation is complete, click Finish.
Cypress > PSoC Programming 3.10 > PSoC Programmer.
ISSP Connector (J3) using the PSoC MiniProg and a USB cable.
Programming 3.10 > PSoC Programmer.
..\Firmware\Capsense Example Project\CY3280_28XXX_SLM\
complete.
(Recommended) option and click Next.
dows Logo testing. Click Continue Anyway each time it appears.
CY3280-28XXX Universal CapSense® Controller Development Kit Guide, Spec. # 001-57457 Rev. **
[+] Feedback