LPC-MT-2138 Olimex Ltd., LPC-MT-2138 Datasheet - Page 4

• Manufacturer Part Number: LPC-MT-2138
• Description: MCU, MPU & DSP Development Tools DEV BRD FOR LPC2138
• Manufacturer: Olimex Ltd.

Specifications of LPC-MT-2138

• Processor To Be Evaluated: LPC2138
• Data Bus Width: 16 bit, 32 bit
• Interface Type: RS-232, I2C, JTAG, SPI, UART
• Dimensions: 4.75 in x 1.5 in
• Operating Supply Voltage: 12 V
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

ELECTROSTATIC WARNING
BOARD USE REQUIREMENTS
PROCESSOR FEATURES
The LPC-MT-2138 board is shipped in protective anti-static packaging. The board
must not be subject to high electrostatic potentials. General practice for working
with static sensitive devices should be applied when working with this board.
LPC-MT-2138 board use LPC2138 microcontroller based on a 16/32-bit
ARM7TDMI-S CPU with real-time emulation and embedded trace support, that
combine the microcontroller with 512 kB of embedded high-speed flash memory. A
128-bit wide memory interface and a unique accelerator architecture enable 32-bit
code execution at maximum clock rate. with these features:
–
–
–
–
–
–
–
–
–
–
–
–
Cables:
meter USB A-B cable to connect ARM-JTAG-EW, ARM-USB-OCD,
and
other programming/debugging tools. You will need a serial cable if not for
programming, than for configuring the board.
Hardware:
applicable, for example ARM-JTAG, ARM-JTAG-EW, ARM-USB-OCD, ARM-
USB-TINY, ARM-USB-TINY-H or other compatible programming/debugging
tool.
32 kB of on-chip static RAM and 256/512 kB of on-chip flash program memory.
128-bit wide interface/accelerator enables high-speed 60 MHz operation.
In-System Programming/In-Application Programming (ISP/IAP) via on-chip
bootloader software. Single flash sector or full chip erase in 400 ms and
programming of 256 B in 1 ms.
EmbeddedICE RT and Embedded Trace interfaces offer real-time debugging
with the on-chip RealMonitor software and high-speed tracing of instruction
execution.
Two 8-channel 10-bit ADCs provide a total of up to 16 analog inputs, with
conversion times as low as 2.44 ms per channel.
Single 10-bit DAC provides variable analog output.
Two 32-bit timers/external event counters (with four capture and four compare
channels each), PWM unit (six outputs) and watchdog.
Low power Real-time clock with independent power and dedicated 32 kHz
clock input.
Multiple serial interfaces including two UARTs (16C550), two Fast I
kbit/s), SPI and SSP with buffering and variable data length capabilities.
Vectored interrupt controller with configurable priorities and vector addresses.
Up to forty-seven 5 V tolerant general purpose I/O pins
Up to nine edge or level sensitive external interrupt pins available.
60 MHz maximum CPU clock available from programmable on-chip PLL with
settling time of 100 ms.
ARM-USB-TINY-H
Depends on the used programming/debugging tool. It could be 1.8
Programmer/Debugger – some of Olimex programmers are
to USB host on PC or LPT cable in case of
Page 4
ARM-JTAG
ARM-USB-TINY
2
C-bus (400
or