BOXD410PT Intel, BOXD410PT Datasheet - Page 38

• Manufacturer Part Number: BOXD410PT
• Description: BOARD, D410PT W/ATOM PROC D410
• Manufacturer: Intel
• Type: Desktop Boardr

Specifications of BOXD410PT

• Kit Features: Single-core Intel Atom Processor, NM10 Express Chipset, Hardware Monitor Subsystem, LAN Support
• Silicon Manufacturer: Intel
• Kit Contents: Board
• Features: 10/100 Integrated LAN, Graphics Output

Clearing Passwords
38
Table 11. Jumper Settings for the BIOS Setup Program Modes
This procedure assumes that the board is installed in the computer and the
configuration jumper is set to normal mode.
1. Observe the precautions in "Before You Begin" on page 23.
2. Turn off all peripheral devices connected to the computer. Turn off the computer.
3. Remove the computer cover.
4. Find the configuration jumper block (see Figure 13, B).
5. Place the jumper on pins 2-3 as shown below.
6. Replace the cover, plug in the computer, turn on the computer, and allow it to
7. The computer starts the Setup program. Setup displays the Maintenance menu.
8. Use the arrow keys to select Clear Passwords. Press <Enter> and Setup displays a
9. Press <F10> to save the current values and exit Setup.
10. Turn off the computer. Disconnect the computer’s power cord from the AC power
11. Remove the computer cover.
Jumper
Setting
press <Enter>. Setup displays the maintenance menu again.
source.
Disconnect the computer’s power cord from the AC power source (wall outlet or
power adapter).
boot.
pop-up screen requesting that you confirm clearing the password. Select Yes and
Mode
Normal (default) (1-2)
Configure (2-3)
Recovery (None)
Description
The BIOS uses the current configuration and
passwords for booting.
After the Power-On Self-Test (POST) runs, the
BIOS displays the Maintenance Menu. Use this
menu to clear passwords.
The BIOS recovers data from a recovery diskette
in the event of a failed BIOS update.